Triaxial-mechanical and permeability properties of coal body under varying CO2 pressures

Lipeng Chen,Lei Wang,Yu Zhang,Kang Jin,Yuxuan Wu,Zhenyu Yang,Zhipeng Liao

DOI: https://doi.org/10.1016/j.scitotenv.2024.174261

2024-10-10

Abstract:The sequestration of CO2 in coal seams has become an effective way to curb greenhouse-gas emissions. Coal mechanics and permeability properties are key factors affecting the safe sequestration of CO2 in coal seams, and both are significantly affected by the CO2 injection pressure. In this study, triaxial compression-permeability tests were conducted on coal under varying CO2 and limited confining pressures using a measurement system to determine the coupled mechanical properties and adsorption permeability of coal. The effects of CO2 pressure on the mechanical properties and evolution of coal permeability were investigated. A three-dimensional statistical damage constitutive model of coal that considers CO2 adsorption damage was established. The results showed that the stress-strain curve of the coal was divided into four stages. During the first two stages, the amplitudes of the permeability changes were small, whereas at the peak stress point, a permeability "jump" phenomenon occurred, after which an increase in stress resulted in a slower amplitude increase in permeability. The CO2 pressure had an evident damage-deterioration effect on the mechanical properties of the coal samples, and the primary failure characteristic was shearing damage. The higher the CO2 pressure, the higher the degree of internal fragmentation and fracture network complexity of the coal body. During the triaxial compression-permeability experiment, the normalized permeability of the coal samples tended to increase slowly, followed by a rapid increase and back to a slow increase. However, with increasing CO2 pressure, the initial permeability of the coal samples decreased, whereas the normalized permeability increased sharply. The rationality and accuracy of the constitutive model were verified by comparing the established constitutive model and test stress-strain curves of the coal samples. The results of this study can provide theoretical references for CO2 geological storage and facilitate the selection of appropriate CO2 injection pressures.