Investigation on the characteristics of oil supply system for a hermetic variable speed rotary compressor

Yihao Zhu,Guogeng He,Wei Sun,Mihoko Shimoji,Xiaoxia Chen

DOI: https://doi.org/10.1016/j.ijrefrig.2020.06.016

IF: 4.14

2020-10-01

International Journal of Refrigeration

Abstract:<p>A hermetic variable speed rotary compressor has a substantially vertically oriented drive shaft, by which the oil is driven upwards and delivered to the lubricating components. To avoid oil starvation or excessive oil supply over a wide range of working speed, it is essential to understand the flow characteristics in such a centrifugal oil pump. In this study, a novel test rig has been built to perform the measurements of oil flow rate under various operating conditions. Several key design parameters in relation to the flow rate such as oil inlet diameter, oil viscosity and oil level height in oil sump have been discussed in detail. The results indicate that the oil flow rate increases up to the speed at which the flow stagnation appears and then starts to slightly decrease with the speed. The stagnation speed decreases with the oil inlet diameter but increases with an augment in oil level height. The oil viscosity does not considerably affect the stagnation speed. Based on the simulated results, it is found that the gas region at oil inlet expands and the effective oil flow area reduces when the rotational speed is high enough. Such behavior of oil flow could be one potential explanation to the occurrence of flow rate stagnation.</p>

engineering, mechanical,thermodynamics

What problem does this paper attempt to address?

The problem that this paper attempts to solve is: **Flow rate characteristics of the oil supply system in variable - frequency rotary compressors and their optimization problems**. Specifically, the author is concerned with how to avoid the problems of insufficient oil supply or excessive oil supply at different rotational speeds. The following are the core problems and research motivations of the paper:

1. **Working principle and challenges of the oil supply system**:
- In variable - frequency rotary compressors, the lubrication system is crucial for ensuring high - performance and high - reliability of the equipment.
- Since the oil supply rate changes with the rotational speed, improper oil pumping may lead to insufficient oil supply (oil starvation) at low frequencies or excessive oil supply at high frequencies.
- Oil starvation may cause direct metal - to - metal contact between moving parts, resulting in severe wear; while excessive oil supply will increase the amount of oil discharged from the compressor into the refrigeration cycle, affecting the performance of the heat exchanger.

2. **Limitations of existing research**:
- Although there have been many studies on the oil supply systems of refrigeration compressors, most of these studies have focused on the oil supply mechanisms under specific conditions and have not explored in detail the influence of the oil inlet diameter on the oil supply rate.
- In particular, previous studies have failed to explain the phenomenon of oil flow rate stagnation at high rotational speeds.

3. **Research objectives**:
- Through experimental tests and numerical simulations, deeply study the flow rate characteristics of the oil supply system at different rotational speeds.
- Analyze the influence of key design parameters such as oil inlet diameter, oil viscosity, and oil level height on the oil flow rate.
- Propose a possible explanation for the cause of oil flow rate stagnation at high rotational speeds.

4. **Expected results**:
- Through this research, a deeper understanding of the characteristics of the oil supply system in variable - frequency rotary compressors can be achieved, thereby providing a theoretical basis for optimizing the oil supply system.
- The research results are helpful for avoiding oil starvation at low speeds and excessive oil supply at high speeds, and improving the reliability and performance of the compressor.

In summary, this paper aims to reveal the flow rate characteristics of the oil supply system in variable - frequency rotary compressors under different working conditions through experiments and numerical simulations, especially to solve the problem of oil flow rate stagnation at high rotational speeds, with a view to optimizing the design of the oil supply system.