Abstract:Fabrication and organosilane-functionalization and characterization of nanostructured ITO electrodes are reported. Nanostructured ITO electrodes were obtained by electron beam evaporation, and a subsequent annealing treatment was selectively performed to modify their crystalline state. An increase in geometrical surface area in comparison with thin-film electrodes area was observed by atomic force microscopy, implying higher electroactive surface area for nanostructured ITO electrodes and thus higher detection levels. To investigate the increase in detectability, chemical organosilane-functionalization of nanostructured ITO electrodes was performed. The formation of 3-glycidoxypropyltrimethoxysilane (GOPTS) layers was detected by X-ray photoelectron spectroscopy. As an indirect method to confirm the presence of organosilane molecules on the ITO substrates, cyclic voltammetry and electrochemical impedance spectroscopy (EIS) were also carried out. Cyclic voltammograms of functionalized ITO electrodes presented lower reduction-oxidation peak currents compared with non-functionalized ITO electrodes. These results demonstrate the presence of the epoxysilane coating on the ITO surface. EIS showed that organosilane-functionalized electrodes present higher polarization resistance, acting as an electronic barrier for the electron transfer between the conductive solution and the ITO electrode. The results of these electrochemical measurements, together with the significant difference in the X-ray spectra between bare ITO and organosilane-functionalized ITO substrates, may point to a new exploitable oxide-based nanostructured material for biosensing applications. As a first step towards sensing, rapid functionalization of such substrates and their application to electrochemical analysis is tested in this work. Interestingly, oxide-based materials are highly integrable with the silicon chip technology, which would permit the easy adaptation of such sensors into lab-on-a-chip configurations, providing benefits such as reduced size and weight to facilitate on-chip integration, and leading to low-cost mass production of microanalysis systems.

Hydroxylation of the indium tin oxide electrode promoted by surface bubbles

Reaction-induced Iodine Adsorption on Cu Surfaces Facilitates Electrocatalytic CO2 Reduction.

Promoting the Electrochemical Water Oxidation Reaction to H2O2 Via Bubbles on the Electrode

Interfacial nanobubbles’ growth at the initial stage of electrocatalytic hydrogen evolution

Construction of iridium oxide nanoparticle modified indium tin oxide electrodes with polycarboxylic acids and pyrophosphoric acid and their application to water oxidation reactions

Electrochemical Studies On The Hydrophilic Mechanism Of Tio2 Thin Films Under Uv Irradiation

Cathode Bubbles Induced by Moisture Electrolysis in TiO2−x-based Resistive Switching Cells

Immobilizing Ordered Oxophilic Indium Sites on Platinum Enabling Efficient Hydrogen Oxidation in Alkaline Electrolyte

Indium oxide with oxygen vacancies boosts O2 adsorption and activation for electrocatalytic H2O2 production

Influence of solution pH on the dynamics of oxygen bubbles on the surface of TiO 2 -NTAs electrodes

Organosilane-functionalization of nanostructured indium tin oxide films

Kinetic study of electrochemically produced hydrogen bubbles on Pt electrodes with tailored geometries

Superhydrophilic/superaerophobic NiFe with Internal Bubble Flow Channels for Electrocatalytic Water Splitting

Boosting the Photocatalytic Activity of Β-Feooh Catalyst for Toluene Oxidation by Constructing Internal Electric Field at 0D/1D Homojunction Interfaces.

Boosting Non-Sacrificial H2O2 Production on a Bi6S2O15 Photocatalyst Via Creating a Crystal Surface-Dependent Internal Electric Field

Electrodeposition of Indium from an Ionic Liquid Investigated by In Situ Electrochemical XPS

X-Ray Photoelectron Spectroscopy Studies Of Indium-Tin-Oxide Treated Via Oxygen Plasma Immersion Ion Implantation

Regulating the work function and surface hydrophobicity of an indium tin oxide electrode for enhanced electrochemiluminescence analysis

Molecular surface functionalization of In2O3 to tune interfacial microenvironment for enhanced catalytic performance of CO2 electroreduction

Surface Renewable Graphite Organosilicate Composite Electrode Containing Indium(Iii) Hexacyanoferrate(Ii/Iii)

Built-in electric field in NiO-CuO heterostructures to regulate the hydroxide adsorption sites for 5-hydroxymethylfurfural electrooxidation assisted hydrogen production