Abstract:The smart diesel program requires the engine electronic control unit to consider additional parameters, such as altitude and climatic conditions, in the mapping calibration process. A specially designed environmental simulation cabin, which can simulate environmental conditions at any longitude and dimension, would allow dynamometer testing to be performed indoors. Considering its high cost, a three-dimensional (3D) computational fluid dynamics (CFD) is needed to guide and/or complement experimental researches. As a result, the main objective of this study was to establish a 3D RANS model (i.e., reasonable computational cost and running time) that can provide in-cylinder details and predict the efficiency of a 6V150 diesel engine under varied operating conditions. A sector mesh approach was employed, considering only the compression, combustion, and expansion periods from intake valve closing to exhaust valve opening. The results indicated that the model simulated cylinder pressure agreed well with the experimental data, with relative errors of less than 6% during the primary compression, combustion, and expansion. Further, the model predicted heat release phasing was inconsistent with the experimental results, with absolute errors of less than one crank angle degree for peak pressure location, CA50, and ignition delay. In addition, the multidimensional model captured the effects of environmental pressure and temperature on spray formation (i.e., the dominant phenomenological event). Moreover, the model reasonably reproduced the effects of engine control variables on performance and emissions. All these observations demonstrated the validity of the selection and calibration of geometry, chemistry, and submodels including turbulence, spray, heat transfer, combustion, etc. Overall, the model was deemed capable of predicting combustion characteristics under extreme conditions, including high-temperature, high-cold, and high-altitude environments, which can facilitate the development of smart engines.

Data-driven models and digital twins for sustainable combustion technologies

Advancing Reacting Flow Simulations with Data-Driven Models

Advanced Modeling Approaches for CFD Simulations of Coal Combustion and Gasification

Toward a Digital Twin of a Solid Oxide Fuel Cell Microcogenerator: Data-Driven Modelling

Multidimensional Computational Fluid Dynamics Combustion Process Modeling of a 6V150 Diesel Engine

A digital twin approach for gas turbine performance based on deep multi-model fusion

Artificial Intelligence-Machine Learning Algorithms for the Simulation of Combustion Thermal Analysis

An Advanced High Dimensional Model Representation Approach for Internal Combustion Engine Modeling and Optimization

Meta-control of combustion performance with a data mining approach

Data-driven Enabling Technologies in Soft Sensors of Modern Internal Combustion Engines: Perspectives

Data-driven models in fusion exhaust: AI methods and perspectives

Data Ecosystems for Scientific Experiments: Managing Combustion Experiments and Simulation Analyses in Chemical Engineering

3D Digital Modeling Technology for Thermal Power Plant Boilers Based on Digital Twins

Preliminary experimental data analysis for Digital Twin development of a large bore Dual-Fuel engine

Combustion Tuning for a Gas Turbine Power Plant Using Data-Driven and Machine Learning Approach

Data-Driven Prediction of Key Combustion Parameters Based on an Intelligent Diesel Fuel Injector for Large Engine Applications

Digital twins for internal combustion engines: A brief review

Combustion model development of future DI engines for carbon emission reduction

Machine Learning of Combustion LES Models from Reacting Direct Numerical Simulation

Requirements Towards Predictive Simulations of Turbulent Reacting Flows

Construction of digital twin model of engine in-cylinder combustion based on data-driven