Abstract:Conventional fluids used in fission‐based water‐cooled nuclear reactors have lower heat transfer coefficients and thermal conductivity, prompting researchers to explore high‐performance fluids to enhance heat transfer and prevent core meltdown during accidents. It is crucial to investigate fluids that can improve thermal hydraulic characteristics, such as the heat transfer coefficient, critical heat flux (CHF), and minimum departure from nucleate boiling ratio (MDNBR). This study investigates the effectiveness of nanofluids in enhancing heat transfer parameters, including thermal conductivity and heat capacity. Results indicate that the silver water nanofluid outperformed the other nanofluids and pure water. The silver water nanofluid demonstrated a 67.15 % improvement in the average heat transfer coefficient and a 45.23 % enhancement in MDNBR compared to pure water. This study underscores the promise of nanofluids, particularly Ag–H2O, in enhancing the thermal performance and safety of water‐cooled nuclear reactors. Future research should continue to explore various nanofluids and their applications to further optimize reactor design and operation, ensuring both efficiency and safety in nuclear energy production. Conventional fluids used in fission‐based water‐cooled nuclear reactors have lower heat transfer coefficients (HTCs) and thermal conductivity, which has led researchers to explore high‐performance fluids that can enhance heat transfer in routine operation and prevent core meltdown in the case of accidents. It is important to investigate a wide range of fluids that can help designers improve thermal hydraulic characteristics, such as HTC, critical heat flux, and minimum departure from nucleate boiling ratio (MDNBR). In this study, the effectiveness of nanofluids in enhancing heat transfer parameters, including thermal conductivity and heat capacity, was investigated. Four different nanofluids (Al2O3–H2O, ZrO2–H2O, Ag–H2O, and Si–H2O) with pure water as the primary coolant in an HPR‐1000 nuclear reactor were compared using computational methods. Due to computational limitations, only the flow channel among four fuel rods with the highest power density in the core was simulated using Eulerian computational fluid dynamics. The results of this study show that silver water (Ag–H2O) nanofluid outperformed other nanofluids and pure water. It had a higher average HTC and MDNBR, with a 67.15 % and 45.23 % improvement, respectively, compared to pure water. The fuel rod wall temperature was also reduced by 28.5 K with Ag–H2O compared to water. Comparison of current simulated results with literature data shows a good agreement.

Enhanced thermal conductivity of plasma generated ZnO-MgO based hybrid nanofluids: An experimental study

Experimental investigation of dispersion stability and thermophysical properties of ZnO/DIW nanofluids for heat transfer applications

Efficient convective heat transfer enhancement in heat exchanger tubes with water based novel hybrid nanofluids: experimental investigation

Experimental study on flow boiling heat transfer augmentation of novel zinc oxide coated copper hybrid nanofluids

Experimental comparison of specific heat capacity of three different metal oxides with MWCNT/ water-based hybrid nanofluids: proposing a new correlation

Thermal Conductivity Enhancement of Metal Oxide Nanofluids: A Critical Review

A thermal energy analysis of binary (Go-Co/H2O) and ternary (Go-Co-Zro2/H2O) nanofluids based on characterization and thermal performance

Experimental investigation of enhanced heat transfer of a car radiator using ZnO nanoparticles in H2O–ethylene glycol mixture

Thermal Performance of Hybrid-Inspired Coolant for Radiator Application

Forced Convective Heat Transfer Coefficient Measurement of Low Concentration Nanorods ZnO-Ethylene Glycol Nanofluids in Laminar Flow

Improved Heat Transfer Capabilities of Nanofluids—An Assessment Through CFD Analysis

Experimental investigation of the thermal performance of a radiator using various nanofluids for automotive PEMFC applications

Heat transfer enhancement in magnetohydrodynamic hybrid nanofluids over a Bi-directional extending sheet with slip and convective conditions

Nanoparticles hybridization in bidirectional flowing of Prandtl–Eyring material with temperature-dependent conductivity: A numerical approach

Distilled Water-Based AlN + ZnO Binary Hybrid Nanofluid Utilization in a Heat Pipe and Investigation of Its Effects on Performance

Experimental investigation of a biomass-derived nanofluid with enhanced thermal conductivity as a green, sustainable heat-transfer medium and qualitative comparison via mathematical modelling

Recent Achievements in Heat Transfer Enhancement with Hybrid Nanofluid in Heat Exchangers: A Comprehensive Review

Exploring thermal flow dynamics in pressurized water reactors using hybrid graphene nanoplatelet coolants

Enhanced thermal effectiveness for electroosmosis modulated peristaltic flow of modified hybrid nanofluid with chemical reactions

Irreversibility analysis of electromagnetic hybrid nanofluid for Cattaneo-Christov heat flux model using finite element approach

Thermal analysis of hybrid nanofluids inside a microchannel heat exchanger for electronic cooling