Moisture transport analysis for integrated structures of flat plate solar collector and building envelope

Guoqing Yu,Jikang Yu,Yue Hu,Xu Cheng,Hongzhi Liu,Weidong Liu

DOI: https://doi.org/10.1016/j.solener.2021.01.068

IF: 7.188

2021-03-01

Solar Energy

Abstract:<p>Accumulation of moisture in the building envelopes may corrode the building structures or deteriorate the indoor environment. In this paper, a hybrid method for moisture transport analysis for solar structures was developed. This hybrid method first adopts state space method to calculate the joint surface temperature between the solar collector and building structure, and then simulate the moisture transport of the building structure by Delphin. The hybrid method was validated by experiments. The moisture transport of an integrated structure of solar collector with a wall, i.e. solar wall, in Shanghai under dry and wet conditions were studied and compared with an ordinary wall by the hybrid method. The results indicated that the solar wall had lower moisture content than ordinary walls in dry conditions. However, if there was wet layer of 10 mm in the wall, the solar wall took much more days to turn dry than the ordinary wall. Therefore, the sealing and waterproof measures should be carefully taken when integrating solar collectors with buildings to prevent water from entering into the solar wall.</p>

energy & fuels

What problem does this paper attempt to address?

The paper aims to study the moisture transfer characteristics after integrating solar collectors with building envelopes and proposes a hybrid method to analyze the moisture transfer process in such integrated structures (i.e., solar walls). Specifically, the paper addresses the following issues:

1. **Study of Moisture Transfer Characteristics**: The paper investigates the moisture transfer characteristics of solar collectors integrated with building envelopes under dry and wet conditions and compares them with ordinary walls.

2. **Development of a Hybrid Method**: The paper proposes a hybrid method that combines the state-space method and Delphin software to simulate the moisture transfer process in building envelopes. This method first uses the state-space method to calculate the interface temperature between the solar collector and the building structure, and then uses Delphin software to simulate the moisture transfer in the building structure.

3. **Experimental Validation**: The effectiveness of the hybrid method is validated through experiments, and the moisture transfer behavior of the solar wall under different conditions is further analyzed.

4. **Importance of Waterproof Measures**: The study finds that under dry conditions, the moisture content of the solar wall is lower than that of ordinary walls; however, under wet conditions, the drying time of the solar wall is much longer than that of ordinary walls. Therefore, special attention should be paid to sealing and waterproof measures when integrating solar collectors to prevent moisture from entering the solar wall.

In summary, this paper aims to explore the moisture transfer characteristics of solar walls under different conditions through theoretical analysis and experimental validation, and emphasizes the importance of waterproof measures.