Abstract:With more and more widely used in the industrial field, Active Magnetic Bearings (AMB) have bigger challenge, such as the size and the load capacity are larger than before. In order to increase the reliability of the whole system, a lot of aspects have to be improved to adapt some special industrial requirements. Just like the 10MW high temperature gas-cooled test module reactor (HTR-10GT) with the core made of spherical fuel elements, which was designed and constructed by the Institute of Nuclear and New Energy Technology of Tsinghua University in China, take the AMB as the support bearings. HTR-10GT is the reactor with 3.5 meter long rotor, 230mm diameter, and 15000rpm Rated speed. Since there are some difficulties in HTR-10GT including the blade stages, small gap and so on, the high precision control on magnetic bearing is required very much. Once any part in the system is out of work, the rotor would happen to vibrate, which will lead to turbine blades scraping. The consequences could be disastrous especially when the system is in full power at the rated speed [1]. As you know, the electronic control system is the weakest point in AMB, both in operating site and the control room. Therefore, before engineering applications, the electronic control system must be tested for Electromagnetic Compatibility (EMC). Based on the experimental results, some design would be optimized, to improve anti-interference capability to meet the requirements of HTR-10GT. This paper describes the testing process and gives some solutions for EMC problems during the Electro Magnetic Susceptibility (EMS) test, such as the grounding, cable, wiring, filtering etc. These methods are the fundamental basis for reducing interference and improving the reliability of AMB in the HTR-10GT.

Long-term follow-up of patients with locally advanced or metastatic thymic malignancies: The Eastern Cooperative Oncology Group (ECOG) experience.

Design of Temperature Testing System in Multi-Parameter Combined Environmental Test

Research on thermal cycle system for real-time PCR instrument based on equivalent circuit model

A Novel Method For On-Line Junction Temperature Measurement Of Power Modules

Exploring Thermal Interface Materials for Electronics Via Molecular Dynamics Simulations: A Review

A Thermal Network Model for Multichip Power Modules Enabling to Characterize the Thermal Coupling Effects

DESIGN AND IMPLEMENTATION OF REDUNDANT SENSORS IN ACTIVE MAGNETIC BEARING

Thermal Characteristic Investigation for a Multichip Module Based on APDL

Numerical Analysis and Design of Thermal Management System for Lithium Ion Battery Pack Using Thermoelectric Coolers

Three dimemsional electro-thermal coupled Monte Carlo device simulation

Mechanical Simulation Analysis of Aerospace High Reliability Electronic Equipment

Design and thermal characteristic test of a temperature control system for spacecraft precision instrument

Thermal Analysis and Simulation of Auxiliary Bearings and Its Application in the High Temperature Reactor-10

Numerical simulation and experiment for thermal behavior of stratospheric electronic equipment

Thermal Estimation and Thermal Design for Coupling Coils of 6.6 kW Wireless Electric Vehicle Charging System

Anti-interference Performance of the Temperature Acquisition System for the Vacuum Thermal Test

Comparative Study of Simulation of Temperature Rise in Ring Main Unit

Numerical and experimental study on thermal management of NCM-21700 Li-ion battery

THE ELECTRO MAGNETIC COMPATIBILITY TESTS FOR THE AMB SYSTEM ON HTR-10GT

Numerical and Experimental Investigation on the Performance of Battery Thermal Management System Based on Micro Heat Pipe Array

Thermal-mechanical Reliability Analysis of Connection Structure Between Redistribution Layer and TSV for MEMS Packaging