Investigation of cutting forces of glass sphere reinforced polymer compositesUntersuchung der Schnittkräfte von glaskugelverstärkten Polymerverbundwerkstoffen

F. Ficici

DOI: https://doi.org/10.1002/mawe.202300381

2024-11-10

Materialwissenschaft und Werkstofftechnik

Abstract:In this study, drilling of glass sphere reinforced polypropylene composites was carried out. The cutting forces generated during drilling were analysed experimentally and the results were verified by statistical analysis. The wear mechanisms occurring in the drill bit as a result of the drilling process were investigated with the help of scanning electron microscopy. In this study, the effects of reinforcement ratio, drill bit material, and drilling process parameters on the cutting forces generated during the drilling of glass sphere‐reinforced polypropylene composites were investigated experimentally. Test specimens were produced by conventional injection‐moulding of glass sphere reinforced polypropylene composite materials at 5 %, 10 % and 20 % wt. ratios. High speed steel, titanium‐coated high‐speed steel, and carbide drill bits with 4 mm diameter were preferred for drilling. In addition, the drilling process was carried out on a 3‐axis computer numeric control milling machine. Three different feed rates of 0.05 mm/rev, 0.10 mm/rev, and 0.15 mm/rev and cutting speeds of 12 m⋅min−1, 16 m⋅min−1, and 20 m⋅min−1 were determined for the drilling process. In addition, Taguchi experimental optimization method, analysis of variance and scanning electron microscopy were used to investigate the morphology of the drilled surface and the wear mechanisms occurring on the drill bit due to the drilling process. The test findings showed that the maximum torque value was 54.64 N⋅mm and the maximum thrust force was 100.43 N. The optimum test parameter for cutting forces was observed as C1D3FR1CS3. Drill parameter had an effect of 40.96 % on thrust force and 36.11 % on torque.

materials science, multidisciplinary