Abstract:This paper presents an experimental and theoretical study of surface generation in the ultra-precision grinding of hard and brittle materials. The study takes into account the material properties, the relative vibration between the grinding wheel and the workpiece, the machining parameters and the phase shift of the grinding process. The Taguchi approach is employed to study the influence of machining parameters on the surface quality and shows that the feed speed and rotational speed of the workpiece are key factors. Experiments have been conducted to study individual variables, and the results further show that the feed rate and the cross-feed distance have a significant effect on surface generation. It is found that the spirals around the central area of the workpiece are the primary mechanism for surface generation, which originates from the synchronous relative tool-work vibration. The integral part of the ratio of the rotational speed of the grinding wheel to rotational speed of the workpiece determines the number of spirals and its fractional part controls the spiral geometry. A theoretical model for predicting the single spiral generation has been developed to explain the accumulation of the phase shift and the geometry. The changeable feed speed near the end of grinding is also modelled, revealing the approximate straight lines around one circle in the central region. The simulated results indicate that the theoretical models and the ground surfaces are in close agreement. The scallop-height model is developed to calculate the influence of phase shift on surface quality, and it is found that the phase shift near the medium value can effectively improve surface quality. Finally, a comparison of different surface generation mechanisms in grinding mould steel, tungsten carbide (WC) and reaction bonded silicon carbide (RB-SiC) is made. It is interesting to note that the Spanzipfel effect contributes to the surface generation not only on ductile materials such as mould steel but also on brittle materials such as WC and RB-SiC. The Spanzipfel effect is the most significant in grinding mould steel. For WC and RB-SiC, the ground surface contains both a ductile region and a brittle region in the form of micro-fractures.

Surface microcosmic morphology evaluation of finished by abrasive jet with grinding wheel as restraint

Experimental Verification of Validity on Abrasive Jet Precision Finishing with Grinding Wheel as Restraint

Studies on the Surface Quality of the Unsteady-State Grinding Technique

Influence of diamond wheel grinding process on surface micro-topography and properties of SiO2/SiO2 composite

An Experimental Investigation on Ultrasonic Vibration-Assisted Grinding of Sio2f/Sio2 Composites

Theoretical Generalization and Research on the Mechanism of the Unsteady-State Grinding Technique

Study on Mechanism for Material Removal and Surface Generation by Molecular Dynamics Simulation in Abrasive Processes

Geometry Simulation and Evaluation of the Surface Topography in Five-Axis Ball-End Milling

An experimental and theoretical analysis of surface generation in the ultra-precision grinding of hard and brittle materials

Generation Mechanism Modeling of Surface Topography in Tangential Ultrasonic Vibration-Assisted Grinding with Green Silicon Carbide Abrasive Wheel

Experimental investigation on the effet of input paramètres on surface roughness and MRR of abrasive flow machining process

A simulation method for surface height distribution of end-face grinding workpieces

Study on the effect of the strengthen grinding process surface coverage on the micro-morphology, micro-hardness, roughness, and residue stress of GCr15 bearing steels

Three-dimensional modelling and simulation of vibration marks on surface generation in ultra-precision grinding

Mechanism analysis and process optimization of nanogrinding single-crystal SiC

On surface texture evolution in abrasive flow machining

Towards understanding the influence of process parameters during the abrasive jet machining of cemented carbides via response surface method

Analytical and experimental study on micro-grinding surface-generated mechanism of DD5 single-crystal superalloy using micro-diamond pencil grinding tool

Experimental Analysis of Ductile Cutting Regime in Face Milling of Sintered Silicon Carbide

Surface Generation Analysis in Micro End-Milling Considering the Influences of Grain

The Modelling and Experimental Verification of the Grinding Wheel Topographical Properties Based on the 'Through-the-process' Method