Abstract:Previous studies suggested that Zintl phases related to the Ca9Zn4.5− δ Sb9 (0 δ x Cu x Sb9 indicated that they could achieve an optimized zT around 0.7. Especially for Ca9Zn4.5− δ Sb9, a very recent report suggested that a high zT of 1.1 at 875 K could be obtained in combination of various secondary phases introduced by the variation of Zn contents, which provided a chemical potential to change the composition. However, to change the composition of Ca9Zn4.5− δ Sb9 is actually very difficult to implement owing to the narrow homogeneity range. In this work, with Ca substituted by big cations such as Eu2+ and Sr2+, the unit cell of Ca9Zn4.5− δ Sb9 was expanded, and similar significant enhancement on the thermoelectric performance was resulted. All syntheses were handled inside a glovebox, then the reactants were loaded in the Nb tube and arc-welded, which were enclosed in a fused silica tube. The reactions were firstly heated to 1173 K in 6 h and then maintained at this temperature for 24 h. After the homogeneity process, the furnace was slowly cooled down to 873 K at a rate of 6 K/h, followed by another dwelling for 6 hours and finally cooled down to 573 K at a rate of 10 K/h. At last, the furnace was shut down and the reactions were opened in the glovebox. The compound were fully characterized by single-crystal X-ray diffraction (SXRD) and powder X-ray diffraction(PXRD), Energy dispersive spectrometer (EDS) and Hall effect measurement, etc. Single-crystal X-ray diffraction (SXRD) proves that with the increase of Sr component, the crystal parameters are slightly increasing. Hall effect measurement show that the substitution of Ca by Eu or Sr can both lead to an obvious decreasing on the carrier (holes) concentration, and the resultant mobility for Sr/Eu-doped materials is very similar if compared by the same doping level. It is also noted that neither the carrier concentration nor the mobility seems to vary linearly with the Eu/Sr-doping contents, which means a saturated state will be eventually approached. This phenomenon is consistent with the speculation above that the changes on the properties should predominantly originate from the change of interstitial Zn content, which the size effect dominated. While the decreasing carrier concentrations as well as the increasing mobility and lattice thermal conductivity all point to a structure modification, the crystal structures of these doped materials were systematically verified through the single crystal X-ray diffraction. In conclusion, although a direct measurement on such a small composition variation is very difficult (the X-ray diffraction results prove it), the significantly reduced carrier concentration and increased mobility as well as lattice thermal conductivity can still provide some useful hints on understanding the property optimization of these materials. For material Ca8.2Eu0.8Zn4.5− δ Sb9, high figure of merit with ZT ~0.81 has been achieved at 873 K.

Sr 9 Mg 4.45(1) Bi 9 and Sr 9 Mg 4.42(1) Sb 9 : Mg-Containing Zintl Phases with Low Thermal Conductivity

Structure, Magnetism, and Thermoelectric Properties of Magnesium-Containing Antimonide Zintl Phases Sr14MgSb11 and Eu14MgSb11.

Zintl Phase Compounds Mg3Sb2−x Bi X (x = 0, 1, and 2) Monolayers: Electronic, Phonon and Thermoelectric Properties from Ab Initio Calculations

A14MgBi11 (A = Ca, Sr, Eu): Magnesium Bismuth Based Zintl Phases As Potential Thermoelectric Materials

Zintl Phase Yb 1– x Ba x Mg 2 Bi 1.98 Compounds with Enhanced Thermoelectric Performance Caused by Cation Substitution

Synthesis of Zintl Phase Metal Silicide Thermoelectric Materials in Magnesium/Zinc Flux

Promising Zintl-Phase Thermoelectric Compound SrAgSb

Zintl Phase Yb1–xBaxMg2Bi1.98 Compounds with Enhanced Thermoelectric Performance Caused by Cation Substitution

Planar Zintl-phase high-temperature thermoelectric materials XCuSb (X = Ca, Sr, Ba) with low lattice thermal conductivity

Sr/Eu Cation Doping and Thermoelectric Properties of the Compound Ca9Zn4.5−δSb9 (0<Δ<0.5)

Enhanced Thermoelectric Properties of Zintl Phase YbMg2Bi1.98 Through Bi Site Substitution with Sb

Achieving High Thermoelectric Performance in Rare-Earth Element-Free CaMg 2 Bi 2 with High Carrier Mobility and Ultralow Lattice Thermal Conductivity

Thermoelectric Properties of Nanocrystalline (mg1−xznx)3sb2isostructural Solid Solutions Fabricated by Mechanical Alloying

The First Quaternary Bismuthide Zintl Phase Ba8Zn2-xIn3+xBi10 with complex Crystal Structure

Higher Thermoelectric Performance of Zintl Phases (eu 0.5 Yb 0.5 ) 1−x Ca X Mg 2 Bi 2 by Band Engineering and Strain Fluctuation

Thermoelectric Properties of New Zintl Phases: Ba/sub 4/in/sub 8/sb/sub 16/ and Ba/sub 6/ge/sub 25-X/

Zintl-Phase Compounds With Snsb4 Tetrahedral Anions: Electronic Structure And Thermoelectric Properties

New Zintl Phase Yb10MgSb9 with High Thermoelectric Performance

Identifying the Promising N-Type SmMg2Sb2-based Zintl Phase Thermoelectric Material

A Dual Role by Incorporation of Magnesium in YbZn2Sb2 Zintl Phase for Enhanced Thermoelectric Performance

Enhanced Thermoelectric Performance of Zintl Phase Ca9Zn4+ xSb9 by Beneficial Disorder on the Selective Cationic Site