Abstract:A challenge of any biosensing technology is the detection of very low concentrations of analytes. The fluorescence interference contrast (FLIC) technique improves the fluorescence-based sensitivity by selectively amplifying, or suppressing, the emission of a fluorophore-labeled biomolecule immobilized on a transparent layer placed on top of a mirror basal surface. The standing wave of the reflected emission light means that the height of the transparent layer operates as a surface-embedded optical filter for the fluorescence signal. FLIC extreme sensitivity to wavelength is also its main problem: small, e.g., 10 nm range, variations of the vertical position of the fluorophore can translate in unwanted suppression of the detection signal. Herein, we introduce the concept of quasi-circular lenticular microstructured domes operating as continuous-mode optical filters, generating fluorescent concentric rings, with diameters determined by the wavelengths of the fluorescence light, in turn modulated by FLIC. The critical component of the lenticular structures was the shallow sloping side wall, which allowed the simultaneous separation of fluorescent patterns for virtually any fluorophore wavelength. Purposefully designed microstructures with either stepwise or continuous-slope dome geometries were fabricated to modulate the intensity and the lateral position of a fluorescence signal. The simulation of FLIC effects induced by the lenticular microstructures was confirmed by the measurement of the fluorescence profile for three fluorescent dyes, as well as high-resolution fluorescence scanning using stimulated emission depletion (STED) microscopy. The high sensitivity of the spatially addressable FLIC technology was further validated on a diagnostically important target, i.e., the receptor-binding domain (RBD) of the SARS-Cov2 via the detection of RBD:anti-S1-antibody.

In-plane Extended Nano-coulter Counter (XnCC) for the Label-free Electrical Detection of Biological Particles

High Sensitivity Extended Nano-Coulter Counter for Detection of Viral Particles and Extracellular Vesicles

An optical nanofibre-enabled on-chip single-nanoparticle sensor

Monolithic Integration of Vertical Thin-Film Transistors in Nanopores for Charge Sensing of Single Biomolecules

An Aptamer Based Wall-Less LSPR Array Chip for Label-Free and High Throughput Detection of Biomolecules.

A Label-free Nanowell-based Impedance Sensor for Ten-minute SARS-CoV-2 Detection

Optical trapping assisted label-free and amplification-free detection of SARS-CoV-2 RNAs with an optofluidic nanopore sensor

Detection of SARS-COV-2 by functionally imprinted micelles

Cmos-Compatible Silicon-Nanowire-Based Coulter Counter for Cell Enumeration

Label-Free Digital Detection of Intact Virions by Enhanced Scattering Microscopy

Rapid single-molecule detection of COVID-19 and MERS antigens via nanobody-functionalized organic electrochemical transistors

Rapid SARS-CoV-2 Spike Protein Detection by Carbon Nanotube-Based Near-Infrared Nanosensors

Cell‐sensing Analogue Nanopore for Rapid Detection of Protein‐Related Targets

Rapid Detection of SARS-CoV-2 Genetic Targets Using Nanoporous Waveguide Based Competitive Displacement Assay

An Integrated System for Optical and Electrical Detection of Single Molecules/particles Inside a Solid-State Nanopore

Spatially Addressable Multiplex Biodetection by Calibrated Micro/Nanostructured Surfaces

Differential Microfluidic Sensor on Printed Circuit Board for Biological Cells Analysis

SARS‐CoV‐2 Virus Detection Via a Polymeric Nanochannel‐Based Electrochemical Biosensor

Interfacial Polymer Engineered Field Effect Transistor Biosensors for Rapid and Efficient Identification of SARS‐CoV‐2 N Antigen

Accessible detection of SARS-CoV-2 through molecular nanostructures and automated microfluidics

N protein-based ultrasensitive SARS-CoV-2 antibody detection in seconds via 3D nanoprinted, microarchitected array electrodes