Abstract:Tanks and silos are often designed as ring-stiffened cylindrical shells. Nowadays, the load-increasing effect of closely spaced ring stiffeners under axial compression has received limited attention in research and practice. Considering the structural safety, the ring-stiffened shell needs to be estimated on the conservative side in practice. This is not desirable in terms of modern lightweight steel structures. However, material efficiency is achieved by combining thin plates with ring-stiffeners. In this paper, small specimen experimental series are carried out to calibrate numerical models, which are subsequently used in parameter studies, because the large-scale experiments are cost-intensive and therefore difficult to carry out in the laboratory. The small cylindrical shells are manufactured by welding of two half-cylindrical shells and the ring stiffeners are spot-welded to the cylindrical shell. Geometric dimension of shell specimens is measured by 3D scanning technology. The measured geometric imperfection information is directly imported into the numerical model based on a mapping relationship and the buckling tests are recalculated by means of geometrically and materially nonlinear analysis with imperfection. The results indicate that the buckling resistance calculated by the Finite Element analysis is very close to that of the test results. The initial geometric imperfection is discussed with reference to the Eurocodes design standard. Furthermore, influence of the ring-stiffener parameter, including imperfection amplitude, radius over thickness ratio, geometry of ring stiffener etc., on the buckling load and knockdown factor is discussed based on a large number of parameter study.

Reliability analysis for ultimate strength evaluation methods of ring-stiffened cylindrical shells under hydrostatic pressure

A semi-analytical analysis of strength and critical buckling behavior of underwater ring-stiffened cylindrical shells

Elastic Buckling of Functionally Graded Rings Under Hydrostatic Pressure

On Instability Failure of Corroded Rings under External Hydrostatic Pressure

Buckling and material failure analyses for ring-stiffened composite shells subjected to hydrostatic pressure

Ultimate strength models for spherical shells under external pressure: a comparative study

Analytical Study on the Buckling of Cylindrical Shells with Stepwise Variable Thickness Subjected to Uniform External Pressure

Isogeometric Method for Buckling Prediction and Post-Buckling Analysis of Variable Stiffness Composite Underwater Pressure Shell

Experimental and numerical buckling analysis of cylindrical pressure hulls with multi-circular openings

Buckling of ring-stiffened cylindrical shell under axial compression: Experiment and numerical simulation

Analysis on Buckling Performance of Submarine Pipelines During Deepwater Pipe-Laying Operation

Numerical Simulation Analysis on Buckling Load of Large Combined Cylindrical Shells

Effects of Ringed Stiffener on the Buckling Behavior of Cylindrical Shells with Cutout under Axial Compression: Experimental and Numerical Investigation

Finite Element Analysis of Tangential Rectangle Joint Pipe on the Shell of an Cyclone

Analytical Research on Dynamic Buckling of Thin Cylindrical Shells with Thickness Variation under Axial Pressure

Analysis on Ultimate Bearing Capacity of Deepwater Submarine Pipe

Vibration and critical pressure analyses of functionally graded combined shells submerged in water with external hydrostatic pressure

Buckling of Cylindrical Shells with Arbitrary Circumferential Thickness Variations under External Pressure

Local buckling of deepwater oil-gas pipeline under high hydrostatic pressure

Advanced empirical formulae for the ultimate strength assessment of continuous hull plate under combined biaxial compression and lateral pressure

Physical correction factor in ultimate strength calculation of deep-sea pressure-resistant cylindrical shells made of TC4, Ti80 and 18Ni(250)