Abstract:Purpose: This prospective longitudinal study reports on the results in patients given autologous tooth material for augmentation in a sinus elevation procedure. Materials and methods: Six patients with inadequate bone supply for augmentation in the maxillary posterior tooth region and at least one impacted maxillary third molar underwent sinus elevation surgery with lateral access using the particulate tooth material. One of the patients received four implants during the same session, while the other patients had a total of 15 implants placed after a healing phase of an average 5.5 months. Drill cylinders collected from the implant bed during the procedure were subjected to histologic/immunohistochemical evaluation. Results: All six patients showed normal and unobtrusive postoperative healing, having undergone prosthetic restoration up to 5 years before. The average peri-implant probing pocket depth after a period of up to 5 years ranged between 1.86 mm (mesial and lingual) and 2.07 mm (distal and buccal). No bleeding could be triggered with any of the peri-implant probes. The average peri-implant bone resorption measured during the first year was up to 0.63 mm, with the lowest being 0 mm and the maximum 2.9 mm. Peri-implant bone remained stable for the follow-up time of up to 5 years. Histologically, six biopsy specimens collected from five patients showed osteoconductive osteogenesis with encapsulation of tooth enamel and dentin portions and partial resorption of the tooth components. Cementum shares were no longer discernible. Immunohistochemical assessment showed intense new vessel formation that could be observed in the area of loose stroma of reorganized tissue in the augmented area. Conclusion: Within the limits of these preliminary results and with adequate consideration of the small number of patients included, the use of autogenous crushed tooth material from impacted third molars may represent an alternative augmentation material for use in sinus elevation procedures.

Autogenous solid dentin for horizontal ridge augmentation with simultaneous implantation in a severe bone defect: A 3.5-year follow-up clinical report

A three-in-one alveolar process reconstruction protocol for maxillary molar sites with severe residual bone height deficiency: A proof-of-concept pilot study

Immediate implant placement using autogenous bone graft with autologous platelet-rich fibrin (A-PRF) for severe vertical bone loss: A case report

Clinical evaluation of ridge augmentation using autogenous tooth bone graft material: case series study

Auto-dentin platelet-rich fibrin matrix is an alternative biomaterial for different augmentation procedures: A retrospective case series report

Autogenous bone ring augmentation around single tooth implantation in the esthetic zone: A retrospective case series study with 2–3 years of follow-up

Retrospective Radiological and Clinical Study

Advances in autogenous dentin matrix graft as a promising biomaterial for guided bone regeneration in maxillofacial region: A review

Horizontal ridge augmentation in the maxillary aesthetic region using the autogenous circular cortical‐lamina anchoring technique: A case series study

Autogenous Dentin Particulate Graft for Alveolar Ridge Augmentation with and without Use of Collagen Membrane: Preliminary Histological Analysis on Humans

A New Method Using Autogenous Impacted Third Molars for Sinus Augmentation to Enhance Implant Treatment: Case Series with Preliminary Results of an Open, Prospective Longitudinal Study

Horizontal ridge augmentation with a resorbable membrane and particulated autogenous bone with or without anorganic bovine bone-derived mineral: a prospective case series in 22 patients

Autogenous Dentin Graft in Bone Defects after Lower Third Molar Extraction: A Split-Mouth Clinical Trial

Lateral Alveolar Ridge Augmentation with Autogenous Tooth Roots and Staged Implant Placement—5-Year Follow-Up Case Series

Using the intact periosteum for horizontal bone augmentation of peri-implant defects: a retrospective cohort study

Technical Considerations and Case Series Reports

Histologic and Clinical Evaluation of Ridge Augmentation of Extraction Sockets with Severe Bone Defects: A Clinical Prospective Study

Staged horizontal bone augmentation for dental implants in aesthetic zones: A prospective randomized controlled clinical trial comparing a half-columnar bone block harvested from the ramus versus a rectangular bone block from the symphysis.

Clinical, Tomographic, and Histologic Evaluation of an Autogenous Bone Graft Harvested from the Maxillary Tuberosity for Guided Bone Regeneration: Case Report with a 4-Year Follow-up.

Bilamina Cortical Tenting Grafting Technique for Three-Dimensional Reconstruction of Severely Atrophic Alveolar Ridges in Anterior Maxillae: A 6-Year Prospective Study.

Inverted bone block for a mandibular lateral ridge augmentation: A case report