Macroscopic and microscopic mechanical characteristics and crack propagation behavior of sandstone-like samples with single cracks under freeze-thaw cycles: Experimental and numerical simulation
Jiabing Zhang,Yiling Chen,Ronghuan Du,Xianglian Zhao,Jun Wu
DOI: https://doi.org/10.1016/j.tafmec.2023.104201
IF: 4.374
2023-11-20
Theoretical and Applied Fracture Mechanics
Abstract:In permafrost regions, rock engineering projects inevitably suffer from the effects of freeze-thaw (F-T) cycles under complex geographical and climatic conditions. Under F-T cycles, the damage and deterioration of macro- and microdefects, such as joints and cracks, in the rock will reduce the structural stability of the rock and even lead to frost damage in rock engineering. In this study, through indoor F-T cycle tests, uniaxial/triaxial compression tests, acoustic emission monitoring, and discrete element method (PFC 3D) modeling, the macro/microscopic mechanical characteristics and crack propagation behavior of sandstone-like samples with single cracks under F-T cycles were investigated. The results show that the compressive strength of sandstone-like samples with single cracks tends to decrease and then increase with an increasing crack angle and exhibits a stable decreasing trend with increasing F-T cycles, indicating a significant crack angle effect and F-T deterioration effect. Additionally, the confining pressure has an inhibiting effect on the F-T deterioration of samples, and there is a mutual inhibition relationship between the F-T deterioration effect and the crack angle effect. The characteristics of the acoustic emission signals during the loading process of sandstone-like samples with single cracks show good consistency with the stress-strain curves. The analysis of fracture mechanisms based on rise time/amplitude (RA) and average frequency (AF) is consistent with the macroscopic failure modes observed in the experiments. Moreover, with an increase in the number of F-T cycles, the number of tension cracks in the sandstone-like samples with single cracks increases, while the number of shear cracks decreases. The crack propagation behavior of sandstone-like samples with single cracks obtained through discrete element simulations (PFC 3D) is mainly divided into four stages: Stage I - initial calm stage, Stage II - crack initiation stage, Stage III - crack propagation stage, and Stage IV - failure stage. The simulated mechanical properties and failure modes agree well with the experimental results, and five crack propagation modes of sandstone-like samples with single cracks under F-T cycles were proposed: direct tension (DT), relative tension (RT), shear-tension (ST), direct shear (DS) and relative shear (RS).
engineering, mechanical,mechanics