Abstract:Safety basis calculations support the safety considerations necessary for legacy nuclear facilities as they transition from active use, through limited operations and standby modes, until final disposition is achieved. Many of the calculations are governed heavily by the coefficients presented in DOE-HDBK-3010 in the form of airborne release of radioactive material resulting from penetration of the facility per seismic activity, full facility fires, and/or explosions. The main objective of this study is to validate the original data for airborne release fractions (ARFs) for powder contaminants under impact, as determined in DOE-HDBK-3010. The limited data available for impact experiments was generated at the Rocky Flats Plant in 1987, where the median ARFs for surrogate powder contamination were 4E-4 with a bounding value of 1E-2. However, estimating the level of uncertainty was challenging in the absence of multiple measurements conducted under identical test conditions. Moreover, the uncertainty was significantly increased due to the restricted range of the test conditions. A more modern approach has been developed for the experimental design in this study, utilizing standardized techniques and analytical instruments. An impact apparatus was employed to be able deliver repeatable impact forces up to 369 kg·cm (320 in.·lb.). Cesium chloride was used as the surrogate powder contaminant in these experiments as it is extremely soluble in water and is even more so in the acidic media used to leach/dissolve the air filters for concentration analysis using mass spectrometry The developed approach leveraged multiple international standards and historical documents in an attempt to recreate a valid testing system that can be used for future analysis and to analyze mitigation factors such as contamination fixative technologies. The current ARFs were found to be consistent with the original values in DOE-HDBK-3010, 3.47E-4 and 4E-4, respectively.

A CFD-based approach to study the deposition and distribution behaviour of 212Pb in a calibration chamber

A Computational Fluid Dynamics code for aerosol and decay-product studies in indoor environments

A CFD-based approach to optimize operating parameters of a flow-through scintillation cell for measurement of 220Rn in indoor environments

Computational fluid dynamics modelling for indoor radioactive pollutant study

Deposition Rates on Smooth Surfaces and Coagulation of Aerosol Particles Inside a Test Chamber

Computational analysis of radon progeny deposition patterns in the human respiratory system

A new dry deposition model implemented in CALPUFF code to simulate contamination of radionuclides released into atmospheric environment post-nuclear accidental event

Thoron Gas Measurement Using Airflow-Through Scintillation Cell with Consideration of Progeny Deposition

The Study of Radioactive Fallout Source of Low-Equivalent Nuclear Bursts Based on Nuclear Cloud Simulation Using the CFD-DPM

CFD Modeling of Aerosol Transport and Deposition Using a Drift-Flux Model

Verification of Size-Resolved Population Balance Modeling for Engineered Nanoparticles under High Concentration

The method of Pb-212 measurements in air with the application of the LSC technique

Be-7 and Pb-210 in fallout and aerosols in 2000-2016 in central Europe - Deposition velocity and dependence on meteorological parameters.

Simulation of the Concentrations and Distributions of Indoor Radon and Thoron

Experimental study of aerosol deposition in distal lung bronchioles

Determination of Airborne Release Fractions from Loose Powder Contamination Under Impact Stress

Behavior of 222Rn, 220Rn and their progenies along a daily cycle for different meteorological situations: Implications on atmospheric aerosol residence times and Rn daughters' equilibrium factors

A computational modeling of airflow and radon progeny deposition in human respiratory system

Mapping the deposition of C137s and I131 in North America following the 2011 Fukushima Daiichi Reactor accident

Study on thermophoretic deposition of micron-sized aerosol particles by direct numerical simulation and experiments

A Critical Analysis of the CFD-DEM Simulation of Pharmaceutical Aerosols Deposition in Upper Intra-Thoracic Airways: Considerations on Aerosol Transport and Deposition