Different effects of fluoride and phosphate anions on TiO2 photocatalysis (rutile)
Jianjun Zhao,Shengwei Liu,Xiao Zhang,Yiming Xu
DOI: https://doi.org/10.1039/D0CY01111H
IF: 6.177
2020-01-01
Catalysis Science & Technology
Abstract:Rutile is the thermally most stable form of TiO2, and can be produced at a high temperature, with a large number of photogenerated charge carriers on the oxide surface potentially available to reactants. However, rutile is seldom studied as a photocatalyst for organic oxidation, due to its poor ability for O2 sorption and reduction in aqueous solution. Herein the effects of NaF and NaH2PO4 on rutile photocatalysis have been examined. For phenol degradation in aqueous solution, these anions were detrimental, with the trend contrary to those reported with anatase, brookite, and P25 (a mixture of anatase and rutile). After rutile was deposited with 0.5% Pt, however, these anions were beneficial, with the trend similar to those observed for a Pt-deposited anatase and P25. At the same amounts on Pt/rutile, interestingly, fluoride was approximately 3 times more active than phosphate, as observed for Pt/anatase. At a surface coverage higher than 90%, however, the positive effect of phosphate became smaller as its adsorption was increased. An independent measurement with a rutile film electrode showed that both fluoride and phosphate inhibited the adsorption and reduction of O2, while they promoted the hole oxidation of phenol. A plausible mechanism is proposed, involving the fluoride-induced enhancement of bridged oxygen/hydroxyl radical formation and the hole oxidation of phosphate into the anion radicals.