Abstract:Organic field‐effect transistors (OFETs) based on two‐dimensional (2D) monolayer organic semiconductors (OSC) have demonstrated promising potentials for various applications, such as light emitting diode (LED) display drivers, logic circuits, and wearable electrocardiography (ECG) sensors. To date, the fabrications of this class of highly crystallized 2D organic semiconductors (OSC) are dominated by solution shearing. As these organic active layers are only a few molecular layers thick, their compatibilities with conventional thermal evaporated top electrodes or sophisticated photolithography patterning are very limited, which also restricts their device density. Here, we develop an electrode transfer stamp and a semiconductor patterning stamp to fabricate OFETs with channel lengths down to 3 μm over a large area without using any chemicals or causing any damage to the active layer. Two‐dimensional (2D) 2,9‐didecyldinaphtho[2,3‐b:2′,3′‐f]thieno[3,2‐b]thiophene (C10‐DNTT) monolayer OFETs developed by this new approach shows decent performance properties with a low threshold voltage (VTH) less than 0.5 V, intrinsic mobility higher than 10 cm2 V−1 s−1 and a subthreshold swing (SS) less than 100 mV dec−1. The proposed patterning approach is completely comparable with ultra‐flexible parylene substrate less than 2 μm thick. By further reducing the channel length down to 2 μm and using the monolayer OFET in an AC/DC rectifying circuit, the measured cutoff frequency is up to 17.3 MHz with an input voltage of 4 V. The newly proposed electrode transfer and patterning stamps have addressed the long‐lasting compatibility problem of depositing electrodes onto 2D organic monolayer and the semiconductor patterning. It opens a new path to reduce the fabrication cost and simplify the manufacturing process of high‐density OFETs for more advanced electronic or biomedical applications. This article is protected by copyright. All rights reserved

Realization of Ohmic-contact and velocity saturation in organic field-effect transistors by crystallized monolayer

Crystallized Monolayer Semiconductor for Ohmic Contact Resistance, High Intrinsic Gain, and High Current Density

A Transfer Method for High‐Mobility, Bias‐Stable, and Flexible Organic Field‐Effect Transistors

The Origin of Low Contact Resistance in Monolayer Organic Field‐Effect Transistors with van der Waals Electrodes

Enhancing The Uniformity of Organic Field‐Effect Transistors by a Single‐Crystalline Layer‐Controlled Active Channel

Interfacial Flat-Lying Molecular Monolayers for Performance Enhancement in Organic Field-Effect Transistors

Modulating Contact Properties by Molecular Layers in Organic Thin‐film Transistors

Ultralow contact resistance in organic transistors via orbital hybridization

Solution-processed top-contact electrodes strategy for organic crystalline field-effect transistor arrays

Liquid Crystal-Like Active Layer for High-Performance Organic Field-Effect Transistors

Interface Collaborative Strategy for High Mobility Organic Single‐Crystal Field‐Effect Transistors with Ideal Current–Voltage Curves

Designing Contact Independent High‐Performance Low‐Cost Flexible Electronics

High Electrical Conductivity and Carrier Mobility in Ocvd PEDOT Thin Films by Engineered Crystallization and Acid Treatment

A Dry-Transfer Method for Molecular Monolayer Crystals Toward Flexible High-Performance Organic Field-Effect Transistors

High‐Speed Organic Single‐Crystal Transistor Responding to Very High Frequency Band

Tuning Interfacial Properties by Spontaneously Generated Organic Interlayers in Top‐Contact‐Structured Organic Transistors

Dry Lithography Patterning of Monolayer Flexible Field Effect Transistors by 2D Mica Stamping

Low-voltage, High-performance Organic Field-Effect Transistors Based on 2D Crystalline Molecular Semiconductors

Reduced contact resistance in top-contact organic field-effect transistors by interface contact doping

Realizing low-voltage operating crystalline monolayer organic field-effect transistors with a low contact resistance

Semiconductor/dielectric Interface in Organic Field-Effect Transistors: Charge Transport, Interfacial Effects, and Perspectives with 2D Molecular Crystals