Abstract:Several ASTM standards on the fracture of glued and welded joints need attention because they do not consider the Griffith energy criterion of cracking which was proposed a century ago. It is almost as if Griffith never existed because the ASTM definition of failure is the stress criterion postulated by Galileo in 1638 in which stress at failure (i.e. strength = force/area) is defined as the determinant of fracture. Irene Martinez Villegas (Villegas, Rans 2021 Phil. Trans. R. Soc. A 376, 20200296. ( doi:10.1098/rsta.2020.0296 )) shows in this volume that attempts to use ASTM D5868 to standardize welded composite (carbon fibre reinforced polymer, CFRP) lap joints reveal major problems. First, the test is a low angle bend–peel test; not shear. Second, the energy required to break the joint is not emphasized so that joints may have high strength properties but also low toughness; third, the fracture force is not proportional to the lap joint area so the concept of strength independent of sample size is false; fourth, as the CFRP panels are made thicker, the strength rises at constant overlap area so the strength can be any value you want; fifth, the strength of larger joints goes down; this is the size effect noted in many bend-cracking tests, much as Galileo suggested for bent beam fracture in his famous book ‘the larger the machine, the greater its weakness'. The purpose of this paper is to demonstrate that poor ASTM ‘shear strength’ standards should be replaced by a definition of welded lap joint performance based on Griffith's energy conservation argument in which fracture surface energy is the main parameter resisting failure. The foundation of this Griffith-style lap joint analysis for long cracks goes back to 1975 but has been largely ignored until now because it does not fit the Griffith equation for cracked sheets, has no ‘stress intensity factor’, and travels at constant speed, not accelerating like the standard Griffith tension crack. This study of tensile delamination shows that a long lap crack is not driven by stress near the crack but by changes in stored elastic energy in the stretched strips remote from the crack tip, while strain energy release rate is negative. It would be more appropriate to call this lap failure a tensile delamination crack. This article is part of a discussion meeting issue ‘A cracking approach to inventing new tough materials: fracture stranger than friction’.

Nano-samples give higher brittle strength by the Griffith energy principle

Energizing ASTM lap joint fracture standards

Size effects in micro and nanoscale materials fracture

Cracking and Adhesion at Small Scales: Atomistic and Continuum Studies of Flaw Tolerant Nanostructures

Failure of Griffith Theory on Prediction of Theoretical Strength of Ideal Materials

Complexity of crack front geometry enhances toughness of brittle solids

Crack-tip plasticity and intrinsic toughening in nano-sized brittle amorphous carbon

A Mesoscopic Approach for the Size Effect on Fracture Energy of Concrete

On strain-rate sensitivity and size effect of brittle solids: transition from cooperative phenomena to microcrack nucleation

Mechanics of structural size effect in impact brittle fracture of steels and consequent scaling laws for fracture

Flaw-driven Failure in Nanostructures

Microstructural origins of crushing strength for inherently anisotropic brittle materials

A Griffith description of fracture for non-monotonic loading with application to fatigue

Understanding fast macroscale fracture from microcrack post mortem patterns

Size-dependence of fracture processes in intact rocks

Observing the crack tip behaviour at the nanoscale during fracture of ceramics

On the effects of material strength in dynamic fracture: A phase-field study

Size effects in fatigue crack growth in confined volumes: A microbending case study on nc Ni

Atomistic and Continuum Studies of Flaw Tolerant Nanostructuresin Biological Systems

On the Fracture Toughness of Advanced Materials

Crystal Strengths at Micro- and Nano-Scale Dimensions