Abstract:Emissions tests were conducted on two medium heavy-duty diesel trucks equipped with a particulate filter (DPF), with one vehicle using a NOx absorber and the other a selective catalytic reduction (SCR) system for control of nitrogen oxides (NOx). Both vehicles were tested with two different fuels (ultra-low-sulfur diesel [ULSD] and biodiesel [B20]) and ambient temperatures (70ºF and 20ºF), while the truck with the NOx absorber was also operated at two loads (a heavy weight and a light weight). The test procedure included three driving cycles, a cold start with low transients (CSLT), the federal heavy-duty urban dynamometer driving schedule (UDDS), and a warm start with low transients (WSLT). Particulate matter (PM) emissions were measured second-by-second using an Aethalometer for black carbon (BC) concentrations and an engine exhaust particle sizer (EEPS) for particle count measurements between 5.6 and 560 nm. The DPF/NOx absorber vehicle experienced increased BC and particle number concentrations during cold starts under cold ambient conditions, with concentrations two to three times higher than under warm starts at higher ambient temperatures. The average particle count for the UDDS showed an opposite trend, with an approximately 27% decrease when ambient temperatures decreased from 70ºF to 20ºF. This vehicle experienced decreased emissions when going from ULSD to B20. The DPF/SCR vehicle tested had much lower emissions, with many of the BC and particle number measurements below detectable limits. However, both vehicles did experience elevated emissions caused by DPF regeneration. All regeneration events occurred during the UDDS cycle. Slight increases in emissions were measured during the WSLT cycles after the regeneration. However, the day after a regeneration occurred, both vehicles showed significant increases in particle number and BC for the CSLT drive cycle, with increases from 93 to 1380% for PM number emissions compared with tests following a day with no regeneration. Implications: The use of diesel particulate filters (DPFs) on trucks is becoming more common throughout the world. Understanding how DPFs affect air pollution emissions under varying operating conditions will be critical in implementing effective air quality standards. This study evaluated particulate matter (PM) and black carbon (BC) emissions with two DPF-equipped heavy-duty diesel trucks operating on conventional fuel and a biodiesel fuel blend at varying ambient temperatures, loads, and drive cycles.

Assessment of particle and gaseous emissions and reductions from gasoline direct injection passenger car and light-duty truck during passive regeneration

Black carbon emissions in gasoline exhaust and a reduction alternative with a gasoline particulate filter

Impact of Active Diesel Particulate Filter Regeneration on Carbon Dioxide, Nitrogen Oxides and Particle Number Emissions from Euro 5 and 6 Vehicles under Laboratory Testing and Real-World Driving

Evaluating the Filtration Efficiency of Close-Coupled Catalyzed Gasoline Particulate Filter (cgpf) over the WLTC and Simulated RDE Cycles.

Insight into the penalty of exhaust emissions and fuel consumption by DPF regeneration of a diesel passenger car

European Regulatory Framework and Particulate Matter Emissions of Gasoline Light-Duty Vehicles: A Review

Particle filter performance of soot-loaded diesel particulate filter and the effect of its regeneration on the particle number and size distribution

Review of the State-of-the-art of Exhaust Particulate Filter Technology in Internal Combustion Engines

Methodology of diesel particulate filter testing on test bed for non-road engine application

Effects of Continuously Regenerating Diesel Particulate Filters on Regulated Emissions and Number-Size Distribution of Particles Emitted from a Diesel Engine

Particulate Emission Characteristics and GPF Performance of WLTC Cycle Based on Exhaust Gas Simulator

Impact of Test Cycle on Mass, Number and Particle Size Distribution of Particulates Emitted from Gasoline Direct Injection Vehicles

Particulate Emissions from Gasoline Direct Injection Engines: A Review of How Current Emission Regulations Are Being Met by Automobile Manufacturers.

An experimental investigation of particulate emission characteristics of catalytic diesel particulate filters during passive regeneration

Nanoparticle Emissions of DI Gasoline Cars with/without GPF

Research on the filtration and regeneration of fuel borne catalyst diesel particulate filter of diesel engine

Particulate emissions from gasoline direct injection engines: A review of how current emission regulations are being met by automobile manufacturers

Characterizing the particle number emissions of light-duty gasoline vehicles under different engine technologies and driving conditions

An Experimental Investigation of the Impact of Washcoat Composition on Gasoline Particulate Filter (GPF) Performance

Temperature effects on particulate emissions from DPF-equipped diesel trucks operating on conventional and biodiesel fuels

Influence of External Purification Technology on Particulate Emission of GDI Engine