Abstract:Because the disposal of phosphogypsum (PG) can lead to serious contamination of the air, soil, and water, recycling of PG has attracted wide attention. This study investigated the effect and solidification of phosphorus in the production of calcium sulfoaluminate (CSA) cement using PG as the sole CaO source. The effects of three phosphorus impurities (Ca3(PO4)2, CaHPO4, Ca(H2PO4)2) on the decomposition of CaSO4, formation of minerals, microstructure of the clinker, and the hydration and mechanical properties of the cement were studied. Experimental results show that Ca3(PO4)2 and Ca(H2PO4)2 promoted the decomposition of CaSO4 and the formation of clinker minerals with the increase in P2O5 content, whereas CaHPO4 showed a promoting effect only when the P2O5 content was more than 1.5 wt%. The increase in phosphorus incorporation in Ca2SiO4 leads to the transformation of β-Ca2SiO4 to α'-Ca2SiO4 and then to Ca7Si2P2O16. The presence of three phosphates in the clinker enhanced the growth of crystal grains and the generation of a liquid phase. Compared with Ca4Al6SO16 without phosphorus, the hydration reaction of phosphorus-bearing Ca4Al6SO16 started later and ended earlier, and the reaction time was shorter. The presence of phosphorus impurities reduces the 1-day strength of CSA cement but does not affect the development of the 3-day and 28-day strengths. Considering environmental aspects, the solidification of phosphorus in the production of CSA clinker were quantified by measuring the distribution of elements. The results indicated that phosphorus is solidified by Ca4Al6SO16, Ca2SiO4, and Ca4Al2Fe2O10, and Ca2SiO4 has a stronger ability to solidify phosphorus than the other two minerals. Ca3(PO4)2 is more difficult to solidify than CaHPO4 and Ca(H2PO4)2. This study is of great significant to guide the large-scale clean utilization of PG in the production of CSA cement.

Influence of phosphogypsum purification with lime on the properties of cementitious matrices with and without plasticizer

Effect of soluble phosphate, fluoride, and pH in Brazilian phosphogypsum used as setting retarder on Portland cement hydration

Influence of treated waste phosphogypsum materials on the properties of ordinary portland cement

Effect of Phosphogypsum on the Properties of Portland Cement

Thermal and Mechanical Properties Enhancement of Cement Mortar using Phosphogypsum Waste: Experimental and Modeling Study

Influences of pretreatment methods on the mechanical and environmental behaviors of PG-GGBS-LM ternary stabilizer

Application of lime neutralised phosphogypsum in supersulfated cement

Potential use of phosphogypsum in concrete

Study on the mechanical properties of phosphogypsum composite cementing materials based on alkali excitation

Influence of cement on properties of calcined phosphogypsum based composite cementitious materials

Application areas of phosphogypsum in production of mineral binders and composites based on them: a review of research results

Experimental Study on the Material Characteristics of Slag Cement with Various Phosphogypsum Materials

Phosphogypsum-Based Ultra-Low Basicity Cementing Material

Valorization of phosphogypsum as hydraulic binder

Treating waste phosphogypsum for cement and plaster manufacture

An investigation into the effect of various chemical and physical treatments of a South African phosphogypsum to render it suitable as a set retarder for cement

The effects of admixtures on the durability properties of phosphogypsum-based cementitious materials

Development and optimization of phosphogypsum-based geopolymer cement

An Eco-Friendly Phosphogypsum-Based Cementitious Material: Performance Optimization and Enhancing Mechanisms

Recycling phosphogypsum as the sole calcium oxide source in calcium sulfoaluminate cement production and solidification of phosphorus

In-situ remediation of phosphogypsum in a cement-free pathway: Utilization of ground granulated blast furnace slag and NaOH pretreatment