Abstract:Because the disposal of phosphogypsum (PG) can lead to serious contamination of the air, soil, and water, recycling of PG has attracted wide attention. This study investigated the effect and solidification of phosphorus in the production of calcium sulfoaluminate (CSA) cement using PG as the sole CaO source. The effects of three phosphorus impurities (Ca3(PO4)2, CaHPO4, Ca(H2PO4)2) on the decomposition of CaSO4, formation of minerals, microstructure of the clinker, and the hydration and mechanical properties of the cement were studied. Experimental results show that Ca3(PO4)2 and Ca(H2PO4)2 promoted the decomposition of CaSO4 and the formation of clinker minerals with the increase in P2O5 content, whereas CaHPO4 showed a promoting effect only when the P2O5 content was more than 1.5 wt%. The increase in phosphorus incorporation in Ca2SiO4 leads to the transformation of β-Ca2SiO4 to α'-Ca2SiO4 and then to Ca7Si2P2O16. The presence of three phosphates in the clinker enhanced the growth of crystal grains and the generation of a liquid phase. Compared with Ca4Al6SO16 without phosphorus, the hydration reaction of phosphorus-bearing Ca4Al6SO16 started later and ended earlier, and the reaction time was shorter. The presence of phosphorus impurities reduces the 1-day strength of CSA cement but does not affect the development of the 3-day and 28-day strengths. Considering environmental aspects, the solidification of phosphorus in the production of CSA clinker were quantified by measuring the distribution of elements. The results indicated that phosphorus is solidified by Ca4Al6SO16, Ca2SiO4, and Ca4Al2Fe2O10, and Ca2SiO4 has a stronger ability to solidify phosphorus than the other two minerals. Ca3(PO4)2 is more difficult to solidify than CaHPO4 and Ca(H2PO4)2. This study is of great significant to guide the large-scale clean utilization of PG in the production of CSA cement.

Recycling phosphogypsum as the sole calcium oxide source in calcium sulfoaluminate cement production and solidification of phosphorus

Recycling phosphogypsum as a sole calcium oxide source in calcium sulfoaluminate cement and its environmental effects

Phosphogypsum as a component of calcium sulfoaluminate cement: Hazardous elements immobilization, radioactivity and performances

Influence of Phosphorus Impurities on the Performances of Calcium Sulfoaluminate Cement

Calcium sulphoaluminate cements made with phosphogypsum: Production issues and material properties

Investigation on the preparation of low carbon cement materials from industrial solid waste phosphogypsum: Clinker preparation, cement properties, and hydration mechanism

Investigation of Process Parameters of Phosphogypsum for Preparing Calcium Sulfoaluminate Cement

Application of lime neutralised phosphogypsum in supersulfated cement

Preparing sulfoaluminate cement using phosphogypsum as the only calcium oxide source: Effects of fluoride impurities

Belite-calcium Sulfoaluminate Cement Prepared with Phosphogypsum: Influence of P2O5 and F on the Clinker Formation and Cement Performances

Effects of phosphogypsum on hydration properties and strength of calcium aluminate cement

Enhancing the Sustainable Immobilization of Phosphogypsum by Cemented Paste Backfill with the Activation of Γ-Al2o3

Hydration process and fluoride solidification mechanism of multi-source solid waste-based phosphogypsum cemented paste backfill under CaO modification

Efficient precipitation of soluble phosphorus impurities in the recycling of phosphogypsum to produce hemihydrate gypsum

In-situ remediation of phosphogypsum in a cement-free pathway: Utilization of ground granulated blast furnace slag and NaOH pretreatment

Study on the Mechanical Properties, Microstructure and Hydration Mechanism of Phosphogypsum-Based Geopolymer Cement with Added Micron-Sized Silica Particles

Improving the Strength Performance of Cemented Phosphogypsum Backfill with Sulfate-Resistant Binders

Mechanism of calcination modification of phosphogypsum and its effect on the hydration properties of phosphogypsum-based supersulfated cement

Study of Semi-Dry High Target Solidification/Stabilization of Harmful Impurities in Phosphogypsum by Modification

Utilizing Decomposed Phosphogypsum for the Preparation of Belite-Calcium Sulphoaluminate Cement

Development and optimization of phosphogypsum-based geopolymer cement