Abstract:Prior research has established that electrical contractors involved in the construction and maintenance of electrical transmission and distribution (T&D) lines are at extremely high risk of electrocution. The result of inadvertent contact with T&D lines often is death or severe injury that involves damage to internal organs, musculoskeletal disorders, neurological damages and severe burns. The Electrical Safety Foundation International has demonstrated that contact with overhead power lines has been the single largest cause of electrical fatalities over the last decade. To reduce this disproportionate injury rate, electrical contractors implement many strategies such as the use of rubber insulating equipment, and locking devices. Unfortunately, these strategies are often cost-prohibitive in certain construction and maintenance scenarios. Therefore, electrical contractors are faced with complex decisions that involve comparing the cost of injury prevention with the expected safety benefit. This paper presents research that objectively evaluated the risk associated with common T&D construction tasks and the effectiveness of specific injury prevention techniques. The research team then developed a decision support framework that provides electrical contractors with objective safety and cost feedback given specific project characteristics. The results indicate that many of the effective strategies implemented to reduce T&D electrical injuries are very costly (e.g., de-energizing lines). Consequently, under most conditions, the costs of injury prevention far outweigh the cost savings associated with the reduction of injury rates. The implication of these findings is that T&D electrical contractors must highly value the non-monetary benefits of injury prevention in order to improve safety in their sector.

Arc-Flash Energy Reduction Techniques: Zone-Selective Interlocking and Energy-Reducing Maintenance Switching

Continued Investigation of Arc Flash in Single-Phase Systems: Threshold for Possible Hazards

Short Circuit and Arc Flash Study on a Microgrid Facility

Methods for Evaluating DC ARC-Flash Incident Energy in Battery Energy Storage Systems

Active arc suppression based MMC-HVDC DC fault adaptive reclosing

Switching Arc Energy Limitation Approach for LV Circuit Breakers

A comprehensive review of DC arc faults and their mechanisms, detection, early warning strategies, and protection in battery systems

Lightning, Grounding and Protection for Control Systems

Arc Movement Inside an AC/DC Circuit Breaker Working With a Novel Method of Arc Guiding: Part I—Experiments, Examination, and Analysis

Experimental research on the fault arc arcing process and electrode temperature distribution of a 220VAC power system

Experimental Research on the Thermal Characteristic of Low-Voltage Alternating Current (AC) Arc Faults

Electrical Safety in Industrial Construction: An Analysis of 10 Years of Incidents in the Global Engineering, Procurement, and Construction Industry

Safety risk management for electrical transmission and distribution line construction

Surface flashover in 50 years: II. Material modification, structure optimisation, and characteristics enhancement

Arc feature extraction and flashover warning of direct current composite insulator based on image processing using visible discharge images

Experimental Study of Arc Motion Near Splitter Plates in Low-Voltage Switching Devices

The Impact of Post-Furnace Steel Processing Equipment on Reducing Voltage Fluctuations Caused by Arc Furnaces

Modeling the development of low current arcs and arc resistance simulation

Evaluation of Time-Based Arc Flash Detection with Non-contact UV Sensor

Research on Early Fault Detection Method for a New Distribution System Based on Automatic Arc Power

Motion behavior of a high-current fault electric arc occurred in the dead zone of protection in a substation