Abstract:Microwave couplers are used in large numbers in beamforming networks, and their miniaturization can lead to a significant size reduction in the overall phased array. While the miniaturization of 3 dB couplers in the transverse direction (width) has been given considerable attention in the literature, there is minimal to no information on reducing coupler length. This is because of the trade-off between aperture length, bandwidth and coupling strength. The Bethe–Hole theory requires adding multiple apertures in the longitudinal direction for wide bandwidth, thus increasing the device length. Another factor is the aperture size, which determines the coupling strength and puts additional strain on the compactness of a 3 dB coupler. Contrariwise, this paper proposes to merge two weak (and hence compact) coupling mechanisms to design a wideband 3 dB coupler. This is achieved by using a longitudinal rectangular slot and three cross-slots in the transverse direction. Because of weak coupling, the slot sizes are smaller than a conventional 3 dB coupler, hence yielding a device whose length is less than one guided wavelength (λg) without compromising the bandwidth. The presented coupler is 0.63 λg in length, which is smaller than the state-of-the-art while maintaining a fractional bandwidth of 37% that is comparable to half-mode substrate integrated waveguide (HMSIW) couplers.

Design and Implementation of Wideband Monopulse Comparator Based on Inverted-Microstrip Gap Waveguide Technology

Design of a compact rat-race coupler employing electromagnetic bandgap (EBG)-loaded and composite right/left-handed (CRLH) half-mode substrate integrated waveguides (HMSIWs)

Fully Differential mm / sub-mm Wave CMOS Amplifiers

A Broadband Passive Monopulse Comparator Mmic

A Dual-Mode SIW Compact Monopulse Comparator for Sum and Difference Multibeam Radar Applications

W-band Power Divider Based on H-plane Slot Waveguide Bridge

A K-band CMOS Monopulse Comparator Incorporating the Phase-Invertible Variable Attenuator

Design and Fabrication of a New Micromachined Interdigital Coplanar Waveguide

Wideband Directional Coupler Based on Zigzag Coupling and Wedge Structure for Isolation Enhancement

A Broadband 3-Way Power Divider Based on Gap Waveguide for Ka-Band Applications

A Wideband Low-Profile Monopulse Feeder Based on Silicon Micromachining Technology for W-Band High-Resolution System

A Fully Planar Broadband Rat-Race Coupler with Stepped-Impedance and Coupled Microstrip Lines

Design and microwave test of an ultrawideband input/output structure for sheet beam travelling wave tubes

Gap Waveguide Technology: An Overview of Millimeter-Wave Circuits Based on Gap Waveguide Technology Using Different Fabrication Technologies

3D Printed Millimeter-Wave Filtering Monopulse Comparator for Dual-Circularly Polarized Antenna

A Multi-Aperture Technique for Longitudinal Miniaturization of UWB 3 dB Dual-Layer SIW Coupler

Broadband Rectangular Waveguide TE10–TE20 Mode Converter with In-Line Ports and Compact Structure

Ultra-Wideband Filtering 180° Hybrid Coupler with Super Wide Upper Stopband Using Swap Phase Inverter and Electromagnetic Bandgap Structures on Double-Sided Parallel-Strip Line

Wideband Transition Between Rectangular Waveguide and Microstrip Using Asymmetric Fin Line Probe

1-D Wide Scanning Gap Waveguide-Based Slot Array Antenna Using Decoupling Technique for 100 GHz Applications

A Compact Dual-Band Coupler with Arbitrary Power Dividing Ratio Using Broadside-Coupled Microstrip