Abstract:When a soft tube is inflated, it may sometimes show a bulge instability wherein a portion of the tube inflates much more than the rest. The bulge instability is well-understood for hyperelastic materials. We examine inflation of polyurethane tubes whose material behavior is not strictly hyperelastic. Upon inflating at constant rate, the tubes deform into a variety of shapes including irregular axisymmetric shapes with multiple localized bulges, a single axially-propagating bulge, or homogeneous cylindrical shapes. In all cases regardless of the inflation mode, the pressure first rises to a maximum, and then gradually reduces towards a plateau. We document numerous differences as compared to hyperelastic tubes. Most notably a pressure maximum can appear even without bulging, whereas for hyperelastic tubes, a pressure maximum is necessarily accompanied by bulging. Further, the decrease in pressure beyond the maximum occurs gradually over timescales as long as an hour, whereas bulging of hyperelastic tubes induces an instantaneous drop in pressure. We also observe permanent deformation upon deflation, a decrease in the pressure maximum during a subsequent second inflation, and more severe bulge localization at low inflation rates. Existing theory of hyperelastic tube inflation cannot capture the observed behaviors, even qualitatively. Finite element simulations suggest that many of the observations can be explained by viscoelasticity, specifically that a slow material response allows the pressure to remain high for long durations, which in turn allows growth of multiple bulges. Tubes that are not purely elastic show an inflation instability with multiple, slowly-growing bulges. Viscoelasticity, strain-induced damage, and permanent deformation all cause deviations from purely elastic behavior.

Elastomeric tubes with self-regulated distension

Small-strain Folding of Semi-Rigid Elastomer Derives High-Performance 3D-Printable Soft Origami Actuators

Experimental and Numerical Investigation of Bulging Behaviour of Hyperelastic Textured Tubes

Dynamic Wrinkling of a Hydrogel–elastomer Hybrid Microtube Enables Blood Vessel-Like Hydraulic Pressure Sensing and Flow Regulation

Modelling and Characterization of Inflated Dielectric Elastomer Actuators with Tubular Configuration

Homogeneous Large Deformation Analysis of a Dielectric Elastomer Peristaltic Actuator

Design, Fabrication and Control of an Hydraulic Elastomer Actuator

Spatial Electrostrictive Actuations of Flexible Circular Tubes

Design of Strain-Limiting Substrate Materials for Stretchable and Flexible Electronics

Fabrication, Mechanical Modeling, And Experiments Of A 3d-Motion Soft Actuator For Flexible Sensing

Elastomers Grow into Actuators

Semi-Analytical Modeling of Electro-strictive Behavior in Dielectric Elastomer Tube Actuators

Measurement and analysis of deformation behavior of thermoplastic elastomer tube subjected to biaxial tensile stress under loading and unloading

Actuation of cylindrical nematic elastomer balloons

Highly Deformable Actuators Made of Dielectric Elastomers Clamped by Rigid Rings

Inelastic Effects in Bulge Formation of Inflated Polymer Tubes

Electrically Controlled Liquid Crystal Elastomer–based Soft Tubular Actuator with Multimodal Actuation

Bifurcation of a Finitely Deformed Functionally Graded Dielectric Elastomeric Tube

Design, Fabrication and Experiments of a 3D-Motion Soft Elastomer Actuator

Dielectric Elastomer Peristaltic Pump Module with Finite Deformation

Selective Stiffening in Soft Actuators by Triggered Phase Transition of Hydrogel‐Filled Elastomers