Continuous switching sliding mode controller design for single-phase UPS inverter circuit

Gangfeng Yan
DOI: https://doi.org/10.1007/s00202-023-02091-z
IF: 1.63
2024-01-19
Electrical Engineering
Abstract:Single-phase uninterrupted power supply is widely used in various important electric equipment, and is used to provide voltage supply with a small harmonic output. The core part of the uninterrupted power supply is the inverter circuit, which is of great significance to the control of the output voltage of the inverter circuit. This article uses the single-phase full-bridge inverter circuit as the research object. Based on the principle of the circuit, the model of the system is obtained. Then a continuous switching sliding mode controller with double sliding mode surface was proposed, which composed of inverse system plus sliding mode control. The measurement of capacitive current replaces the differential of capacitive voltage to form a sliding mode surface, which solves the problem that the differential of capacitive voltage cannot directly form a stable sliding mode surface. Double sliding mode surface are used instead of traditional single sliding surface to reduce the chattering of the output voltage. For the same sinusoidal expected output waveform, the proposed method and the double closed-loop cascade control are used to control the output waveform of a single-phase full bridge inverter circuit. The control experimental results show that the maximum instantaneous voltage error and total harmonic distortion rate of the proposed method have significantly improved, and have practical engineering value.
engineering, electrical & electronic
What problem does this paper attempt to address?