Abstract:It is difficult to enhance the blue or purple luminescence efficiency of organic light-emitting device ( OLED) for practice display applications. In this work, aluminum nano particles (Al-NPs) are inserted into the light-tight TmPyPb electron transporting layer (ETL) of ITO/PEDOT:PSS/TAPC/BCzVBi:BCPO/TmPyPb/Liq/Al OLEDs, in which BCzVBi can emit deep-blue fluorescent light, with the attempts to overcome the above deficiency through the local surface plasmon polariton(LSPP) effect excited in Al-NP at higher resonance frequencies by the luminescence radiations from BCzVBi. The distances of Al-NPs from BCzVBi:BCPO fluorescent layer are chosen as x = 4, 8, 12 nm. The morphologies observed by atom force microscope and scan electron microscope show that the Al film with a thickness of 1 nm, deposited at room temperature by vacuum heat evaporate, is composed of separated Al grains (therefore, called Al-NPs) with sizes on a 10 nm scale. By inserting these Al-NPs into the TmPyPb ETL, both the current density and luminance at the same voltage decrease in comparison with the counterparts of reference devices (i.e. ones without Al-NPs) due to the worsened carrier mobility. However, the current density and luminance both rebound significantly at x = 8 nm. This may be due to the fact that the fluorescence quenching strongly occurs at x < 8 nm, and on the other hand, the local surface plasmon polariton is weakened too much at x > 8 nm due to attenuated radiation from BCzVBi. At x = 8 nm, the voltage (9 V) at which the luminance reaches a maximum value is the same as that for the reference device, but the maximum luminance itself decreases from 4200 Cd/m 2 to 3500 Cd/m 2 . However, the current density also decreases from 335.19 mA/cm 2 to 145.71 mA/cm 2 . This conversely results in a promising great increase of current efficiency from 0.88 Cd·A –1 to 2.36 Cd·A –1 . Subsequently, the external quantum efficiency (EQE) is enhanced by 170%, while the efficiency roll-off ratio decreases from 78% to 30.5%, with a decrement of 61% . At a high current density of 270 mA/cm 2 , EQE enhances 66.5%. The coupling between fluorescence excitation state and local surface plasmon polariton is determined by the overlapping between fluorescence emitting peak and plasmon resonance peak. As aluminum has a number density of free electrons, 18.1×10 22 cm –3 , much larger than those for the other normally used metals (such as gold and silver), its spectrum of local surface plasmon polariton is enough to cover the fluorescence wavelength range of BCzVBi. These research results show that the luminescence efficiency of deep-blue OLEDs can be turned better by LSPP excited in Al-NPs at higher resonance frequencies.

Synthesis of UV/blue light-emitting aluminum hydroxide with oxygen vacancy and their application to electrically driven light-emitting diodes

Single Source Precursor Chemical Vapor Decomposition Method to Fabricate Stable, Bright Emissive Aluminum Hydroxide Phosphors for UV‐Pumped White Light‐Emitting Devices

Mesoporous Aluminum Hydroxide Synthesized by a Single-Source Precursor-Decomposition Approach as a High-Quantum-Yield Blue Phosphor for UV-Pumped White-Light-Emitting Diodes.

Stable blue-emissive aluminum acetylacetonate nanocrystals with high quantum yield of over 80% and embedded in polymer matrix for remote UV-pumped white light–emitting diodes

Monodisperse CaAl12O19:Mn4+ Microspheres for Full-Spectrum White LEDs

The Optical Spectrum of UVLED Excitation Using NTC Nanometer Particles to Replace Rare Earth Doping

Synthesis of colloidal aluminum hydroxide nanoparticles for transparent luminescent polymer nanocomposite films

Aluminum Quantum Dots with Surface Controlled Blue-UV Photoluminescence

Eu2+-activated MgAl2Si4O6N4: a novel oxonitridoalumosilicate blue phosphor for white LEDs

Luminescent Enhancement of Heterostructure Organic Light-Emitting Devices Based on Aluminum Quinolines

Efficient Deep-Blue Light-Emitting Diodes from Highly Luminescent Eu 2+ -Doped Alkali Metal Halide Nanocrystals via Lattice Field Modulation

A Novel Blue Light Emitting Diode Using Tris(2,3-methyl-8-hydroxyquinoline) Aluminum(III) As Emitter

Zero-thermal-quenching of LiAl5O8: Eu2+, Mn2+ phosphors by energy transfer and defects engineering

Polyethyleneoxide/Sodium Dodecyl Sulfate As Hole-Blocking/Electron-Transporting Layer For High-Performance Blue Polymer Light-Emitting Diode With Oxygen- And Moisture-Stable Aluminum Cathode

Phosphorescent Carbene-Gold-Arylacetylide Materials as Emitters for Near UV-OLEDs

Facile low-temperature solid-state synthesis of efficient blue-emitting Cs3Cu2I5 powder phosphors for solid-state lighting

Phosphonate Functionalized Oxadiazole Derivative As an Efficient Electron Transporting Material for Solution-Processed Blue Electrophosphorescent Devices.

Blue Electroluminescence from Tris-(8-Hydroxyquinoline) Aluminum Thin Film

Influence of High-frequency localized surface plasmon polariton effect of Al nanoparticles on luminescence efficiency of deep-blue BCzVBi OLED

Efficient Hole-Blocker with Electron Transporting Property and Its Applications in Blue Organic Light-Emitting Devices

A hydroxyphenyloxadiazole lithium complex as a highly efficient blue emitter and interface material in organic light-emitting diodes