Abstract:Based on the recently constructed n-body potential, both molecular dynamics and Monte Carlo simulations revealed that the Al-Zr amorphous alloy or metallic glass can be obtained within the composition range of 24–66 at. % Zr. The revealed composition range could be considered the intrinsic glass-forming range and it quantitatively indicates the glass-forming ability of the Al-Zr system. The underlying physics of the finding is that, within the composition range, the amorphous alloys are energetically favored to form. In addition, it is proposed that the energy difference between a solid solution and the amorphous phase could serve as the driving force of the crystalline to amorphous transition and the driving force should be sufficiently large for amorphization to take place. The minimum driving forces for fcc Al-based and hcp Zr-based Al-Zr solid solutions to amorphize are calculated to be about −0.05 and −0.03 eV/atom, respectively, whereas the maximum driving force is found to be −0.23 eV/atom at the alloy stoichiometry of Al60Zr40. A thermodynamics parameter γ¯, defined as the ratio of the driving force to the formation energy of the solid solution, is further proposed to indicate the glass-forming ability of an Al-Zr alloy. Thermodynamics calculations show that the glass-forming ability of the Al56Zr44 alloy is the largest, implying that the Al56Zr44 amorphous alloy is more ready to form than other alloys in the Al-Zr system. Besides, Voronoi analysis found that there exists a strong correlation between the coordinate number and structure. Amorphization could result in increase of coordinate numbers and about 1.5% volume-expansion. The volume-expansion induced by amorphization can be attributed to two factors, i.e., the total bond number of the Al-Zr amorphous phase is greater than that of the corresponding solid solution, and the averaged bond length of the Al-Zr amorphous phase is longer than that of the corresponding solid solution. For the Al-Zr alloys, especially for the Al-Zr amorphous phase, there exists a negative chemical micro-inhomogeneity in the alloys, suggesting that metallic bonds prefer to be formed between the atoms of dissimilar species. Finally, it is found that there is a weak correspondence between the bond-angle distributions of Al-Zr amorphous alloys and the solid solutions. It is further suggested that the configuration of Al-Zr amorphous alloys embodies some hybrid imprint of bcc, fcc, and hcp structures. More interestingly, the short-range order is also observed in the bond-angle distributions.

Infection and Fibrositis

Interatomic Potential to Predict the Favored Glass-Formation Compositions and Local Atomic Arrangements of Ternary Al-Ni-Ti Metallic Glasses

Formation of the Ni–Zr–Al Ternary Metallic Glasses Investigated by Interatomic Potential Through Molecular Dynamic Simulation

Interatomic Potential to Predict the Favored and Optimized Compositions for Ternary Cu-Zr-Hf Metallic Glasses

Thermodynamic Calculation And Interatomic Potential To Predict The Favored Composition Region For The Cu-Zr-Al Metallic Glass Formation

Computation Assisted Design of Favored Composition for Ternary Mg-Cu-Y Metallic Glass Formation

Favored Composition Design and Atomic Structure Characterization for Ternary Al-Cu-Y Metallic Glasses Via Proposed Interatomic Potential.

Prediction of Glass-Forming Ability and Atomic-Level Structure of the Al-Zr-Pd Metallic Glasses by Molecular Dynamics Simulations

Prediction of Favored and Optimized Compositions for Cu-Zr-Ni Metallic Glasses by Interatomic Potential

Atomistic Design Favored Compositions and Atomic-Level Structure of Mg–Ca–Ag Ternary Metallic Glasses

Atomistic modeling to investigate the favored composition for metallic glass formation in the Ca-Mg-Ni ternary system.

Prediction of Glass-Forming Ability and Characterization of Atomic Structure of the Co-Ni-Zr Metallic Glasses by a Proposed Long Range Empirical Potential

Favored Composition Region for Metallic Glass Formation and Atomic Configurations in the Ternary Ni–Zr–Ti System Derived from N-Body Potential Through Molecular Dynamics Simulations

Atomic modeling to design favored compositions for the ternary Ni–Nb–Zr metallic glass formation

Atomistic modeling to optimize composition and characterize structure of Ni-Zr-Mo metallic glasses.

Atomic-Approach to Predict the Energetically Favored Composition Region and to Characterize the Short-, Medium-, and Extended-Range Structures of the Ti-Nb-Al Ternary Metallic Glasses

Glass-Forming Ability And Atomic-Level Structure Of The Ternary Ag-Ni-Zr Metallic Glasses Studied By Molecular Dynamics Simulations

Atomistic Approach to Design Favored Compositions for the Ternary Al–Mg–Ca Metallic Glass Formation

Interatomic Potential to Predict the Glass-Forming Ability of Ni–Nb–Mo Ternary Alloys

Formation and structure of Al-Zr metallic glasses studied by Monte Carlo simulations

Atomistic Design of Favored Compositions for Synthesizing the Al-Ni-Y Metallic Glasses