The Effect of Drying/Re-Flooding on Trace Metal, As and Se Fluxes in a Treatment Wetland: Addressing Growing Environmental Concerns

Drew J Hansen,Alex J Horne
DOI: https://doi.org/10.3390/biology11020188
2022-01-25
Abstract:The retention of heavy metals in water treatment wetlands is well documented, but little understood. Fluxes to and from sediments for moderate concentrations of dissolved metals are particularly unknown. Treatment wetlands are dried out seasonally or occasionally for maintenance. The extent to which heavy metals may be released by drying/re-flooding is of particular concern because of the potential for toxic levels of metals to be mobilized. A 36 ha treatment wetland receiving treated oil refinery effluent in California was dried for 6 months, then re-flooded to an average depth of >10 cm. The concentrations of 11 metals, As and Se in inflow, outflow, and porewaters were measured weekly for 4 months. Mass flux rates showed that the wetland acted as a sink for As and Se, six metals (Co, Cr, Mg, Mn, Ni, and Sr) and S were overall sources and five showed zero net flux (Ba, Cu, Fe, Mo, and Zn). Porewater results indicate that oxidation of the sediments caused the source metals to be released. Removal for As > Cu, Fe, Mo, Zn > Co, Mn, Ni was consistent with the thermodynamically-predicted 'sulfide ladder', suggesting that available sulfide was insufficient to re-sequester the entire pool of mobile chalcophile elements. Our results suggest that less-soluble sulfide metals may be immobilized prior to more-soluble metals following drying/re-flooding in coastal systems with multiple metal contaminants. Ponding for up to several weeks, depending on the metals of concern, will facilitate metal re-immobilization within sediments before waters are released and minimize impacts downstream. Research on how to speed-up the conversion of soluble metals to their insoluble sulfides or other immobilized forms is urgently needed.
What problem does this paper attempt to address?