Abstract:There have been over 17 million COVID-19 infections worldwide up to July 31, 2020, but the exact transmission route remains a subject for debate. Virus load in different-sized respiratory droplets is the key to address the above question. Investigation on the droplet deposition characteristics during exhalation inside the respiratory tract will facilitate the understanding of their origin and importance in transmitting the respiratory infection. Based on a realistic respiratory model, this study utilized the computational fluid dynamic (CFD) simulation to investigate the deposition of droplets originating from infection sites like pharynx, larynx and trachea under three flow conditions, namely 30 L/min (representing the normal breathing condition), 60 L/min (speaking) and 180 L/min (coughing). The SST k-omega turbulence model integrated in ANSYS Fluent software was utilized to obtain the flow field inside the respiratory tract by solving the continuity and momentum equations, and the Lagrangian approach was used to calculate droplet motion and deposition with the discrete random walk model to account for the turbulence fluctuation effect. Evaporation of droplets was not considered inside the saturated respiratory tract. Droplet diameter, flow rate of the exhaling air, and complexity of the respiratory tract geometry are the most important factors in determining the deposition pattern of respiratory droplets. It is revealed that the largest droplet that originates from the joint of pharynx and larynx and is able to escape out of the respiratory tract is about 20 mu m (30 L/min) or 10 mu m (60-180 L/min) in diameter; the so-called cut-off sizes for vocal cord and trachea originated droplets are 7 mu m (30 L/min), 5 mu m (60 L/min) or 3 mu m (180 L/min). Larynx and joint of larynx and pharynx are the most important deposition sites due to their complexity in geometry and the existence of the laryngeal jet, whose velocity is up to 102 m/s during coughing and 32 m/s during speaking; the nasal cavity is also effective in trapping relatively small droplets as the airflow has a sudden change in direction before entering the oral cavity. Under the investigated speaking scenario (60 L/min), the escape rate of 1 mu m droplets is around 50%, and the maximum escape rates of 5 and 10 mu m droplets are respectively 13.1% and 1.3% (originating from the joint of pharynx and larynx). Although large droplets up to several hundred micrometers can be produced inside the oral cavity due to the atomization mechanism, they seldom carry pathogen. Thus, for COVID-19 patents in the early stage of infection who show upper respiratory symptoms, the cut-off size of virus-laden droplets released into the environment is about 20 mu m; with the shifting of infection to the lower respiratory tract in the later stage, the cut-off size decreases to 7 mu m. Respiratory droplets evaporate immediately after escaping into the indoor environments and shrink to about one third of their initial size, so airborne route is speculated to be important in the transmission of COVID-19. Further investigations considering realistic flow conditions together with droplet sampling experiments on human volunteers are necessary to confirm these cut-off sizes.

Transport and dispersion of tracers simulating COVID-19 aerosols in passenger aircraft

Numerical Investigation on the Origin of Virus-Laden Droplets in the Respiratory Tract

A Wells-Riley Based COVID-19 Infectious Risk Assessment Model Combining Both Short Range and Room Scale Effects

A novel VOC breath tracer method to evaluate indoor respiratory exposures in the near- and far-fields; implications for the spread of respiratory viruses

Indoor Model Simulation for COVID-19 Transport and Exposure

A novel VOC breath tracer method to evaluate indoor respiratory exposures in the near- and far-fields

CFD modelling of indoor aerosol transport to infer airborne SARS-CoV-2 transmission risk

A Quantitative Risk Estimation Platform for Indoor Aerosol Transmission of COVID-19

Numerical Simulations of Interpersol Aerosol Transport in a Single-Aisle Aircraft Cabin

Simulation of aerosol transmission on a Boeing 737 airplane with intervention measures for COVID-19 mitigation

Predicting aerosol transmission in airplanes: Benefits of a joint approach using experiments and simulation

Evaluating vacant middle seats and masks as Coronavirus exposure reduction strategies in aircraft cabins using particle tracer experiments and computational fluid dynamics simulations

Droplet and particle methods to investigate turbulent particle laden jets

A comparative analysis of potential aerosol exposure in a wide-body aircraft cabin using tracer gas and fluorescent particles

Simulating near-field enhancement in transmission of airborne viruses with a quadrature-based model

CFD Simulation of the Airborne Transmission of COVID-19 Vectors Emitted during Respiratory Mechanisms: Revisiting the Concept of Safe Distance

Inflight transmission of COVID-19 based on experimental aerosol dispersion data

3D modelling and simulation of the impact of wearing a mask on the dispersion of particles carrying the SARS-CoV-2 virus in a railway transport coach

Indoor transmission of airborne viral aerosol with a simplistic reaction-diffusion model

Modelling of human exhaled sprays and aerosols to enable real-time estimation of spatially-resolved infection risk in indoor environments

Large-scale flow field and aerosol particle transport investigations in a classroom using 2D-Shake-The-Box Lagrangian Particle Tracking