Abstract:Introduction: Hard-on-hard bearings for total hip replacement may require a modular acetabular inlay for which polyethylene is often used in a sandwich-type configuration. However, differences in the elastic modulus of the materials make fixation of this metal insert uncertain. The aim of this study is to report a case of bilateral separation of the metal insert from the polyethylene sandwich in a metal-on-metal bearings prosthesis. Materials and methods: A bilateral total hip arthroplasty was performed in two operations, four months apart, in a 53-year-old woman following a corticosteroid-induced osteonecrosis. The total hip replacement system included a cementless stem, and a press-fit hemispheric cup containing a polyethylene sandwich with a metallic insert (Sikomet). Results: Three years later, the patient consulted because of abnormal noise in her right hip which appeared normal on conventional X-ray. Three months later she consulted again for persistent noise. Separation of the metal insert from the polyethylene sandwich was diagnosed and an acetabular revision was performed selecting a metal-on-polyethylene articulation system. The postoperative course, for this revision, was uneventful, but the patient returned with the similar symptoms in her left hip four months later, resulting in the same type of revision. During the revisions, osteolysis secondary to metallosis was diagnosed, requiring synovectomy and acetabular reconstruction with morcelized allograft impaction. The left side postoperative course included three dislocations in nine months which were conservatively treated and have not since recurred. Discussion and conclusion: This is the first reported case recording an almost simultaneous bilateral dissociation of a hard-on-hard inlay from its polyethylene sandwich. This bilateral case suggests that the fixation of the metal insert inside the polyethylene was probably defective. This case is also a reminder that mechanical complications (separation, implant fracture) should be searched for in presence of any abnormal noise occurring after hard-on-hard bearings prosthetic implantation. This confirms the necessity of periodical follow-up of hip arthroplasties and the importance of knowing their radiological features. The low carbon content of the Sikomet bearing may have been the cause of this failure by increasing frictional torque on the bearing surface, causing metallosis which has already been described in the literature in this type of hip replacement system.

Femoral Head Perforation After Primary Hip Arthroplasty: Unseen Complication of Ceramic-on-Ceramic Interface: A Case Report

Ceramic fragmentation after total hip arthroplasty: two case reports and literature review

Protrusion of a Ceramic Femoral Head Through the Acetabular Metallic Cup in Total-Hip Arthroplasty

Severe Wear and multiple Pseudotumor formation due to revision for ceramic head breakage after ceramic-on-ceramic Total hip arthroplasty: a case report

An Atypical Adverse Local Tissue Reaction After Ceramic-on-Ceramic Primary Total Hip Arthroplasty

Concerns about Ceramics in THA

Mid Term Results of Total Hip Arthroplasty Using Polyethylene-Ceramic Composite (sandwich) Liner

Ceramic-on-ceramic total hip arthroplasty:Pitfalls and strategy

Why Are Contemporary Primary Ceramic-on-Highly Crosslinked Polyethylene Total Hip Arthroplasties Failing? An Analysis of Over 5,500 Cases

New Ceramic Heads with Titanium Sleeves on Retained Femoral Components: Results of Over 500 Revision Total Hip Arthroplasties

Long-term follow-up of total hip arthroplasty using polyethylene-ceramic composite (sandwich) liner

A Rare Complication of Pelvic Perforation by an Excessive Medial Slide of the Helical Blade after Treatment of an Intertrochanteric Fracture with Proximal Femoral Nail Anti-Rotation: A Case Report and Literature Review.

Polyethylene liner dissociation in cementless total hip arthroplasty: Ensuring accurate diagnosis

Caecal perforation secondary to intrapelvic migration of a total hip prosthesis: A case report and a review of the literature

Use of ceramic-on-ceramic bearing in total hip arthroplasty for posttraumatic arthritis of the hip

Catastrophic Periprosthetic Osteolysis in Total Hip Arthroplasty at 20 Years: A Case Report and Literature Review

Preliminary Clinical And Radiographic Results Of Large Ceramic Heads On Highly Cross-Linked Polyethylene

Bilateral simultaneous metal inlay dissociation from the polyethylene liner of a metal-on-metal hip replacement

Mechanical failure of total hip arthroplasties and associated risk factors

A multi-center retrospective comparative study of third generation Ceramic-on- Ceramic total hip arthroplasty in patients younger than 45 years with or without the sandwich liner: A ten-year minimum

Ceramic-on-metal coupling in THA: long term clinical and radiographic outcomes using two different short stems