Co-solvent strategy for highly efficient perovskite solar cells by spray coating

Tie Xu,Yingchen Li,Hongkun Cai,Yinbin Zhu,Chao Liu,Baoyu Han,Zhihao Hu,Fei Zhang,Jian Ni,Juan Li,Jianjun Zhang

DOI: https://doi.org/10.1016/j.solener.2024.112461

IF: 7.188

2024-03-16

Solar Energy

Abstract:The ultrasonic spray coating has been shown to be an effective technique for scaling up production. The nucleation and crystallization process of the perovskite film prepared by the ultrasonic spraying approach is more complicated than that by the spin coating, but they are essential to gaining efficient perovskite solar cells (PSCs). At the same time, the green solvent is the primary problem that must be solved in the process of PSCs commercialization. In this paper, the low boiling point and green solvent isopropyl alcohol (IPA) is introduced into the perovskite precursor solution to prepare FAPbI 3 perovskite by ultrasonic spraying. The addition of IPA enhanced the saturated vapor pressure of the precursor solution, which can create the local chemical microenvironment on the film surface and subsequently retard the nucleation rate from 8.31 s to 8.54 s at nucleation stage. The local chemical improves the initial homogeneity of the sol–gel phase and then leads to improved structural and optoelectronic properties within the FAPbI 3 film via sufficient crystallization from the sol–gel phase to α-FAPbI 3 . Ultimately, IPA-based PSCs exhibit the champion device efficiency of 22.43 %. The good long-term stability of PSCs (maintain more than 90 % of the initial efficiency after 1000 h, and keep 80 % after 400 h) in ambient conditions.

energy & fuels