Decision Criterion for Acid-Stimulation Method in Carbonate Reservoirs: Matrix Acidizing or Acid Fracturing?
Mateus Palharini Schwalbert,Murtada Saleh Aljawad,Alfred Daniel Hill,Ding Zhu
DOI: https://doi.org/10.2118/199236-pa
2020-06-11
SPE Journal
Abstract:Summary Most wells in carbonate reservoirs are stimulated. Because of their low cost and simpler operations, acid-stimulation methods are usually preferred if they are sufficient. Matrix acidizing can effectively stimulate carbonate reservoirs, often resulting in skin factors on the order of −3 to −4. In low confining stress and hard rocks, acid fracturing can yield better results than matrix acidizing. However, acid fracturing is less effective in high permeability, high confining stress, or soft rocks. There is a combination of parameters, among them permeability, confining stress, and rock geomechanical properties, that can be used as criteria to decide whether matrix acidizing or acid fracturing is the best acid-stimulation technique for a given scenario. This study compares the productivity of matrix-acidized and acid-fractured wells in carbonate reservoirs. The criterion used to decide the preferred method is the largest productivity obtained using the same volume of acid for both operations. The productivity of the acid-fractured wells is estimated using a fully coupled acid-fracturing simulator, which integrates the geomechanics (fracture propagation), pad and acid transport, heat transfer, temperature effect on reaction rate, effect of wormhole propagation on acid leakoff, and finally calculates the well productivity by simulating the flow in the reservoir toward the acid fracture. Using this simulator, the acid-fracturing operation is optimized, resulting in the operational conditions (injection rate, type of fluid, amount of pad, and so forth) that lead to the best possible acid fracture that can be created with a given amount of acid. The productivity of the matrix-acidized wells is estimated using the most recent wormhole-propagation models scaled up to field conditions. Results are presented for different types of rock and reservoir scenarios, such as shallow and deep reservoirs, soft and hard limestones, chalks, and dolomites. Most of the presented results considered vertical wells. A theoretical extension to horizontal wells is also presented using analytical considerations. For each type of reservoir rock and confining stress, there is a cutoff permeability less than which acid fracturing results in a more productive well; at higher than this cutoff permeability, matrix acidizing should be preferred. This result agrees with the general industry practice, and the estimated productivity agrees with the results obtained in the field. However, the value of the cutoff permeability changes for each case, and simple equations for calculating it are presented. For example, for harder rocks or shallower reservoirs, acid fracturing is more efficient up to higher permeabilities than in softer rocks or at deeper depths. This method provides an engineered criterion to decide the best acid-stimulation method for a given carbonate reservoir. The decision criterion is presented for several different scenarios. A simplified concise analytical decision criterion is also presented: a single dimensionless number that incorporates all pertinent reservoir properties and determines which stimulation method yields the most productive well, without needing any simulations.
engineering, petroleum