Key factors governing the reconstitution time of high concentration lyophilized protein formulations

Shreya S Kulkarni,Sajal M Patel,Raj Suryanarayanan,Joseph V Rinella Jr,Robin H Bogner

DOI: https://doi.org/10.1016/j.ejpb.2021.05.005

Abstract:Lyophilized protein formulations containing highly concentrated proteins often have long and variable reconstitution times. Reconstitution time is dependent on a number of factors in a complex manner. Furthermore, factors influencing the reconstitution of partially crystalline cakes are reportedly different from those of amorphous cakes. The objectives of this work were to identify the key factors governing reconstitution and understand the mechanisms involved in reconstitution of both amorphous and partially crystalline cakes. Partial crystallinity in the final cake, larger pores and low "concentrated formulation viscosity" (i.e., viscosity near the surface of the dissolving cake) were identified as desirable characteristics for expediting reconstitution. Crystallinity and larger pores dramatically improved wettability and liquid penetration into partially crystalline cakes, ultimately resulting in well dispersed small pieces of partially dissolved cake. The smaller disintegrated cake pieces dissolved faster because of the increased surface area. The amorphous cakes exhibited poorer wettability than partially crystalline cakes. Moreover, the ability of the reconstitution fluid to penetrate the pores, and the resulting cake disintegration was much lower than that observed for partially crystalline cakes. In fact, for some of the amorphous cakes, the reconstitution fluid did not penetrate the cake at all. As a result, the undissolved intact cake or a large cake chunk floated on the reconstitution fluid amidst foam or bubbles generated during reconstitution. Dissolution of the floating cake appeared to proceed via gradual surface erosion where reconstitution time was found to be highly correlated with the viscosity near the surface of the dissolving cake solids. A higher viscosity prolonged reconstitution. Thus, both formulation and processing conditions can be tailored to achieve faster reconstitution. Including a crystallizable excipient proved to be beneficial. Incorporating an annealing step to facilitate crystallization of the crystallizable excipient and to promote larger pores was also found to be advantageous. A viscosity lowering excipient in the formulation could potentially be helpful but needs to be explored further.