Abstract:Background: The increasing emergence and spread of multiresistant microorganisms in hospital wards is a serious concern. Traditional protocols are often not sufficient to protect patients susceptible to serious and life-threatening infections, therefore new strategies for decontaminating hospital environments are crucial to reducing microbial transmission and the spread the nosocomial infections. The adoption of modern technologies is indicated to supplement traditional methods and to improve desired levels of surface disinfection. Aim: This work aims to report the development, implementation, and validation of cleansing and sanitizing procedure for critical clinical settings through the innovative use of disposable cloths pre-impregnated with solutions containing different active formulations and biocidal agents, relating to the areas to be treated (low, moderate, high-risk). Methods: The implementation and validation of the sanitizing system were conducted in different wards of two healthcare structures. The protocol for the study involved a structured selection of representative surfaces, such as the floor, bathroom, desk, and beds. Microbiological analyses were performed according to ISO 4833-1:2013. Findings: The efficiency of the proposed system was measured through the estimation of total microbial count values on the different surfaces before and after the sanitization operations by traditional methods and by the system described here. The results demonstrated a significant reduction in the microbial count that always fell below the threshold value. For the analyzed surfaces such as shower tray, bathroom floor, toilet edge, the traditional system had an effectiveness of less than 10%, whereas pre-impregnated cloths succeed to eliminate about 90% of the bacteria present. As an example, on the floor we observed a microbial count reduction from >42 to 10CFU/11cm2 with the new method (76% of colonies were destroyed), while with the traditional one we have a reduction from >42 to 28CFU/11cm2 (33% of microbial colonies). Moreover, the advantages of using this sanitization system are not limited to disinfecting surfaces and limiting cross-contamination but involve all activities related to the cleaning and disinfection operations, including the training and education of the operators and traceability of the operations. Conclusions: The innovative disinfection and cleaning protocol used in the present study proved to be a highly valuable alternative to the traditional cleaning procedures in healthcare settings for the sanitizing process of all kinds of surfaces. All tools were specifically designed to improve disinfection efficiency and to reduce the problems associated with traditional methods, such as preventing cross-contamination events, limiting the physical efforts of operators, and avoiding incorrect practices. Our findings add support to the knowledge that an effective sanitization procedure is critical in minimizing microorganisms' transmission and cross-contamination.

Development and Improvement of an Effective Method for Air and Surfaces Disinfection with Ozone Gas as a Decontaminating Agent

An alternative approach for the decontamination of hospital settings

Effectiveness of a combined UV-C and ozone treatment in reducing healthcare-associated infections in hospital facilities

Safe and Effective Use of Ozone as Air and Surface Disinfectant in the Conjuncture of Covid-19

Ozone Decontamination of Medical and Nonmedical Devices: An Assessment of Design and Implementation Considerations

No-Touch Automated Disinfection System Based on Hydrogen Peroxide and Ethyl Alcohol Aerosols for Use in Healthcare Environments

Bactericidal efficacy of low dose gaseous ozone against clinically relevant multidrug-resistant bacteria

Ozonated water in disinfection of hospital instrument table

Evaluation of the Effectiveness of Two Automated Room Decontamination Devices Under Real-Life Conditions

Evaluation of an Ultraviolet C (UVC) Light-Emitting Device for Disinfection of High Touch Surfaces in Hospital Critical Areas

Effect of ozone gas on cultures of Candida albicans and Aspergillus fumigatus: evaluation of two ozonation devices

1219. Disinfection of Surfaces Contaminated with Carbapenemase Producing Acinetobacter baumannii Using Ozone Under Complex Room Conditions

Ozone as a disinfectant in laboratory surfaces against the SARS-cov-2 coronavirus

Efficacy of Three Commercial Disinfectants in Reducing Microbial Surfaces’ Contaminations of Pharmaceuticals Hospital Facilities

Effectiveness of ozone generated by a dielectric barrier discharge plasma reactor against multidrug-resistant pathogens and Clostridioides difficile spores

The Application of Ozone Gas in Inactivation of Surface and Airborne SARS-CoV-2 in Hospitals: A Systematic Review

Evaluating the Potential, Applicability, and Effectiveness of Ozone Sterilization Process for Medical Devices

Role of environmental sanitization in health clinics: evaluation of potassium peroxymonosulfate (KMPS) efficacy at two different concentrations

Confirmation of the sterilization effect using a high concentration of ozone gas for the bio-clean room

Ozone Gas: Scientific Justification and Practical Guidelines for Improvised Disinfection using Consumer-Grade Ozone Generators and Plastic Storage Boxes.

Highly effective decontamination in a hospital environment: An easy‐to‐operate, low‐cost prototype