Abstract:The stabilization of asphalt pavement bases with granular soil and aggregates emulsified with asphalt is a widely used technique in road construction and maintenance. It aims to improve the mechanical properties and durability of the lower pavement layers. Currently, there is no consensus on the most suitable method for designing emulsified granular aggregates with reclaimed asphalt pavement (RAP), as it is very complex. Therefore, the methodology is generally based on compliance with one or more volumetric or mechanical parameters established in the highway regulations for conventional asphalt mixtures, which does not guarantee the optimization and characterization of the recycled mixture in the base course. In this study, granular mixtures were developed, including five with emulsion and one emulsion-free as a control mix. Granular RAP mixes were designed in this study, including five with emulsion and one emulsion-free as a control mix. The five mixes ranged from 1% to 5% emulsion and were characterized by multi-stage triaxial tests with repeated load resilient modulus (RM) and permanent deformation (PD) to evaluate their mechanical behavior. The results showed that the mixes had RM values between 350 and 500 MPa, consistent with literature values. However, they showed similar levels of accumulated deformation to the control mix without RAP emulsion. The sample with 1 % RAP emulsion exhibited a satisfactory RM value and better performance in PD than the control mix (5 mm) and showed accumulated PD values of up to 4 mm. In contrast, the other samples exhibited deformations of up to 6 mm. In this study, the multi-stagge triaxial RM and PD tests were found to be an effective predictive method for characterizing the behavior of RAP materials in base courses, regardless of the types of admixtures contained. Multi-stage resilient modulus and PD tests can be considered as a predictive method for the behavior of milled material in base courses. They were able to provide initial data for interpreting the behavior of ETB mixtures.

Effect of carbonation of soil-slag mixtures on the resilient behaviour and structural response of an asphalt pavement

Laboratory Evaluation On The Performance Of Porous Asphalt Mixture With Steel Slag For Seasonal Frozen Regions

Inverse Engineering Stress-Dependent Resilient Moduli of Cement-Treated Base Materials in Asphalt Pavements Using Falling Weight Deflectometer

Cold Recycled Asphalt Mixture using 100% RAP with Emulsified Asphalt-Recycling Agent as a New Pavement Base Course

Carbon dioxide emissions and heavy metal contamination analysis of stone mastic asphalt mixtures produced with high rates of different waste materials

Effects of short-term aging on the mechanical and structural performance of hot mix asphalt mixtures: a case study complemented by statistical analysis

The influence of residual asphalt material in the mechanical behaviour of soil-RAP mixtures for use in paving

Application of electric arc furnace slag for stabilisation of different tropical soils

Effect of Water Erosion on the Dynamic Modulus of Steel Slag Asphalt Mixture

Investigation of Permanent Deformation Behavior of Steel Slag Asphalt Mixture under Indoor Simulation

Effect of Steel Slag on the Permanent Deformation and Life Cycle Cost of Asphalt Concrete Pavements

Dynamic Properties of Reclaimed Asphalt Pavement–Green Cement Blends for Road Base Layer

Functional and structural assessment of an experimental section gap graded modified with sugarcane bagasse ash

Sustainability-oriented assessment of pavement technologies: A case study of a heavy-traffic highway in Brazil

Use of steel slag to improve the mechanical properties of subgrades in clayey soils

Study on the performance and sustainability of modified waste crumb rubber and steel slag powder/SBS composite modified asphalt mastic

Mechanical Performance and Life Cycle Assessment of Soil Stabilization Solutions for Unpaved Roads from Northeast Brazil

Mechanism of Reinforced Interfacial Adhesion Between Steel Slag and Highly Devulcanized Waste Rubber Modified Asphalt and Its Influence on the Volume Stability in Steel Slag Asphalt Mixture

Assessment of carbon dioxide emissions during production, construction and use stages of asphalt pavements

Sustainable Reclaimed Asphalt Emulsified Granular Mixture for Pavement Base Stabilization: Prediction of Mechanical Behavior Based on Repeated Load Triaxial Tests

Expansion Level of Steel Slag Aggregate Effects on Both Material Properties and Asphalt Mixture Performance