Abstract:PurposeBrain shift during tumor resection can progressively invalidate the accuracy of neuronavigation systems and affect neurosurgeons' ability to achieve optimal resections. This paper compares two methods that have been presented in the literature to compensate for brain shift: a thin-plate spline deformation model and a finite element method (FEM). For this comparison, both methods are driven by identical sparse data. Specifically, both methods are driven by displacements between automatically detected and matched feature points from intraoperative 3D ultrasound (iUS). Both methods have been shown to be fast enough for intraoperative brain shift correction (Machado et al. in Int J Comput Assist Radiol Surg 13(10):1525–1538, 2018; Luo et al. in J Med Imaging (Bellingham) 4(3):035003, 2017). However, the spline method requires no preprocessing and ignores physical properties of the brain while the FEM method requires significant preprocessing and incorporates patient-specific physical and geometric constraints. The goal of this work was to explore the relative merits of these methods on recent clinical data.MethodsData acquired during 19 sequential tumor resections in Brigham and Women's Hospital's Advanced Multi-modal Image-Guided Operating Suite between December 2017 and October 2018 were considered for this retrospective study. Of these, 15 cases and a total of 24 iUS to iUS image pairs met inclusion requirements. Automatic feature detection (Machado et al. in Int J Comput Assist Radiol Surg 13(10):1525–1538, 2018) was used to detect and match features in each pair of iUS images. Displacements between matched features were then used to drive both the spline model and the FEM method to compensate for brain shift between image acquisitions. The accuracies of the resultant deformation models were measured by comparing the displacements of manually identified landmarks before and after deformation.ResultsThe mean initial subcortical registration error between preoperative MRI and the first iUS image averaged 5.3 ± 0.75 mm. The mean subcortical brain shift, measured using displacements between manually identified landmarks in pairs of iUS images, was 2.5 ± 1.3 mm. Our results showed that FEM was able to reduce subcortical registration error by a small but statistically significant amount (from 2.46 to 2.02 mm). A large variability in the results of the spline method prevented us from demonstrating either a statistically significant reduction in subcortical registration error after applying the spline method or a statistically significant difference between the results of the two methods.ConclusionsIn this study, we observed less subcortical brain shift than has previously been reported in the literature (Frisken et al., in: Miller (ed) Biomechanics of the brain, Springer, Cham, 2019). This may be due to the fact that we separated out the initial misregistration between preoperative MRI and the first iUS image from our brain shift measurements or it may be due to modern neurosurgical practices designed to reduce brain shift, including reduced craniotomy sizes and better control of intracranial pressure with the use of mannitol and other medications. It appears that the FEM method and its use of geometric and biomechanical constraints provided more consistent brain shift correction and better correction farther from the driving feature displacements than the simple spline model. The spline-based method was simpler and tended to give better results for small deformations. However, large variability in the spline results and relatively small brain shift prevented this study from demonstrating a statistically significant difference between the results of the two methods.

Biomechanical modelling and computer aided simulation of deep brain retraction in neurosurgery

A comparison of brain retraction mechanisms using finite element analysis and the effects of regionally heterogeneous material properties

In Vivo Investigation of the Effectiveness of a Hyper-viscoelastic Model in Simulating Brain Retraction.

Biomechanical modeling and computer simulation of the brain during neurosurgery

Computer simulation of tumour resection-induced brain deformation by a meshless approach

Patient-specific model of brain deformation: application to medical image registration

A framework for correcting brain retraction based on an eXtended Finite Element Method using a laser range scanner

Position-based Dynamics Simulator of Brain Deformations for Path Planning and Intra-Operative Control in Keyhole Neurosurgery

A Sparse Intraoperative Data-Driven Biomechanical Model to Compensate for Brain Shift During Neuronavigation

Development and biomechanical testing of full-scale human brain simulant

Construction & validation of linear elastic model of intraoperative brain deformation during neurosurgical navigtion

Bio-Mechanical Model of the Brain for a Per-Operative Image-Guided Neuronavigator Compensating for "Brain-Shift" Deformations

Computational modeling of whole-brain dynamics: a review of neurosurgical applications

Modeling brain dynamics after tumor resection using The Virtual Brain

[A Preliminary Clinical Validation of a Brain Deformation Corrective System Based the Linear Elastic Model].

Intraoperative interaction modeling between surgical instruments and soft tissues in neurosurgery based on energy functions

Modeling electrical impedance in brain tissue with diffusion tensor imaging for functional neurosurgery applications

Developing a high fidelity, low cost simulation model for retrosigmoid craniotomy and microvascular decompression of the trigeminal nerve

A comparison of thin-plate spline deformation and finite element modeling to compensate for brain shift during tumor resection

A brain-deformation framework based on a linear elastic model and evaluation using clinical data.

Development and evaluation of a craniocerebral model with tactile-realistic feature and intracranial pressure for neurosurgical training