Abstract:Fiber-reinforced biological soft tissues are often modeled as anisotropic hyperelastic materials. Four strain invariants can be used to define a strain energy function for soft tissues reinforced with a single fiber family: two isotropic invariants I 1 , I 2 and two anisotropic invariants I 4 , I 5 . Invariant I 5 is often omitted in the strain energy functions to simplify the problem mathematically. In this study, the implications of using only I 4 or the use of both anisotropic invariants I 4 , I 5 in the numerical modeling of soft tissues were analyzed. A simple modification to the Holzapfel–Gasser–Ogden (HGO) model is proposed by adding a term that contains invariant I 5 . Material parameters were calculated by fitting the models with experimental data of uniaxial traction in the tibialis anterior tendon tissue of rats. General analytical solutions for the simple load scenarios were obtained. Such solutions are taken as a reference point to measure the precision of the numerical results obtained in the finite element simulations. The main differences between the models were observed in the shear behavior. The proposed model predicts three different shear responses (two responses with fiber reinforcement and one isotropic response), while the HGO model predicts two equal isotropic responses and only one with fiber reinforcement. Two sets of simple shear experimental data on a fiber-reinforced elastomer material were used to verify the shear stress prediction of the models. The experimental data show that the three shear behaviors are different; thus, the HGO model offers a limited description of the shear behavior. Furthermore, analytical solutions and experimental data suggest that invariant I 5 is related to the elastic energy of the fibers when the material is subjected to shear in a direction parallel to the fibers. The models for non-homogeneous deformations were also compared. For this comparison, an irregular geometry was implemented in ABAQUS, and the traction and shear conditions were simulated by changing the fiber inclination. The most critical difference was found when the shear was parallel to the direction of the fiber and the minor difference when the fiber was at 45° to the load force.

In vitro compressive properties of skeletal muscles and inverse finite element analysis: Comparison of human versus animals

Fully non-linear hyper-viscoelastic modeling of skeletal muscle in compression

ESTABLISHMENT AND APPLICATION OF LOWER LIMB FINITE ELEMENT MODEL BASED ON MUSCLE GROUPS

Simulation of Active Cardiac Dynamics with Orthotropic Hyperelastic Material Model

Simulation of active skeletal muscle tissue with a transversely isotropic viscohyperelastic continuum material model

Multiscale modeling of skeletal muscle to explore its passive mechanical properties and experiments verification

Development of an Inverse Approach for the Characterization of In Vivo Mechanical Properties of the Lower Limb Muscles

Viscoelastic properties of passive skeletal muscle in compression-cyclic behaviour

Three Dimensional Skeletal Muscle Tissue Modelling

Development of a Finite Element Musculoskeletal Model with the Ability to Predict Contractions of Three-Dimensional Muscles.

Dynamic compressive response of porcine muscle measured using a split Hopkinson bar system with a pair of PVDF force transducers

Combining Freehand Ultrasound-Based Indentation and Inverse Finite Element Modeling for the Identification of Hyperelastic Material Properties of Thigh Soft Tissues

In vivo mechanical response of thigh soft tissues under compression: A two-layer model allows an improved representation of the local tissue kinematics

Finite Element Analysis of Active Muscle Response Based on Parameters of Constitutive Models

A novel progress of leg tissue properties modeling based on biomechanics

Mechanical Properties of Porcine Extraocular Muscles in Vitro

A visco-hyperelastic model for skeletal muscle tissue under high strain rates.

Calibrating the Nonlinear Elastic and Viscoelastic Tissue Properties of Left Ventricular Muscle from Guinea Pig Heart

Structural Changes of Active Skeletal Muscles: Modelling, Validation and Numerical Experiments

Topographic Mapping and Compression Elasticity Analysis of Skinned Cardiac Muscle Fibers in Vitro with Atomic Force Microscopy and Nanoindentation.

Role of anisotropic invariants in numerically modeling soft biological tissues as transversely isotropic hyperelastic materials: A comparative study