Abstract:Low-temperature water electrolysis can rapidly produce environmentally sustainable or green hydrogen, and is a prospective means of storing energy from renewable but intermittent power sources, such as wind and solar, in future clean energy infrastructure (1-4). Commercial water electrolysis either use liquid alkaline electrolyte or proton exchange membrane electrolyte (1). The proton exchange membrane water electrolysis (PEMWE) offers more advantages than the alkaline counterpart, such as higher purity of H 2 , lower resistance losses, more compact design, and what the most important is the compatible with the intermittent of the renewable energy (1-2). The grant challenge remaining in PEMWE is the development of the highly active, cost effective and stable catalysts for oxygen evolution reaction (OER), which is very sluggish requiring large amounts of precious metal as the catalysts, such as Ir, Ru and their oxides (1). In PEM water electrolysis cells, the catalysts should have high surface areas and high porosities that exposit sufficient active sites available to the reactants and electrolyte, as well as transferring the bubble out of the catalyst surface to ensure a fast mass transfer (5). Also, the OER is dependent on the inherent conductivity of the catalysts or the supports (1). For example, poor electronic conductivity within the catalyst layer will result in poor lateral conductivity across the catalyst layer, thus catalyst not in the vicinity of the porous transport layer will not participate in the reaction. To enable the widespread penetration of the PEMWE technologies, it is urgently to reduce the Ir loading to the sustainable level (~ 0.3 mg/cm 2 ) compared with the current commercial usage (2-6 mg/cm 2 ). Alternatively, to develop precious metal free catalyst with high efficiency and sustained durability (5). In this presentation, we will describe a method of preparing highly active yet stable synergistic electrocatalysts for oxygen evolution reaction for PEMWE. The new catalysts contain IrCoOx/ RuCoOx cluster and La&Li co-doped Co 3 O 4 fiber which was derived from cobalt zeolitic imidazolate framework as precursor. The OER activities of the catalysts were first tested in O 2 saturated acidic electrolyte by ring disk electrode (RDE), which displayed high mass activity 26-50 times that of commercial Ir and RuO 2 . The catalysts were fabricated into membrane electrode assemble and measured under real PEM water electrolysis condition. The cells demonstrated 2 A/cm 2 @1.76 V @0.25 ± 0.05 mg Ir /cm 2 loading, and negligible degradation after ~250 h chronoamperometric measurements at 2 A/cm 2 (6), which meets the target set by US DOE for OER catalysts for PEMWE. The characterizations of the fresh and post-electrochemical samples were investigated by X-ray photoelectron spectroscopy (XPS), X-ray diffraction (XRD), X-ray absorption near-edge structure (XANES), extended X-ray absorption fine structure (EXAFS), transmission electron microscopy (TEM), Raman spectroscopy and BET surface analysis. We also performed DFT simulation on the OER reaction pathways over Ir and Co sites of different facets parallelly on basis of the TEM results. The result reveals the synergy between Ir/Ru and Co resulting in the enhanced catalytic activities of both IrCoOx /RuCoOx and LaLi@Co 3 O 4 toward OER. Acknowledgments: This work was supported by Overseas Outstanding Youth Fund project, shanghai Jiao Tong university, Shanghai, China; Shanghai Pujiang talent Plan, Shanghai, China; Argonne National Laboratory through Maria Goeppert Mayer Fellowship, US; State Key Laboratory of Metal Matrix Composites, shanghai Jiao Tong university, Shanghai, China. The works performed at Hydrogen research center, shanghai Jiao Tong university, and Argonne National Laboratory’s Center for Nanoscale Materials and Advanced Photo Source. Reference: K. Ayers et al., Annu. Rev. Chem. Biomol. Eng. 10, 219–239 (2019). M. Carmo, D. L. Fritz, J. Mergel, D. Stolten, Int. J. Hydrogen Energy 38, 4901–4934 (2013). M. T. M. Koper, J. Electroanal. Chem. 660, 254–260 (2011). R. D. L. Smith et al., Science 340, 60–63 (2013). Chong et al., Science 380, 609–616 (2023). Chong et al., Adv. Energy Mater. 2023, 2302306.

Fabrication of a Robust PEM Water Electrolyzer Based on Non-Noble Metal Cathode Catalyst: [Mo3 S13 ]2- Clusters Anchored to N-Doped Carbon Nanotubes

N, P co-doped Ni/Mo-based multicomponent electrocatalysts in situ decorated on Ni foam for overall water splitting

An oxide-promoted, self-supported Ni4Mo catalyst for high current density anion exchange membrane water electrolysis

Interfacial engineering of atomic platinum-doped molybdenum carbide quantum dots for high-rate and stable hydrogen evolution reaction in proton exchange membrane water electrolysis

Investigating the Effects on Replacing Platinum by Molybdenum as Cathode Electrocatalysts in Proton Exchange Membrane Water Electrolysis

Phosphorus dopants triggered single-atom platinum catalysis for efficient hydrogen evolution in proton exchange membrane electrolyzers

S-Doped MoP Nanoporous Layer Toward High-Efficiency Hydrogen Evolution in Ph-Universal Electrolyte

Synergistic Electrocatalysts Impact Efficient and Durable Oxygen Evolution Catalysis for Proton Exchange Membrane Water Splitting

PGM-Free Oxygen Evolution Reaction Catalyst for PEM Water Electrolysis – a Mechanistic Study on Activity and Durability for Practical Applications

Defect-balanced Active and Stable Co3O4-x for Proton Exchange Membrane Water Electrolysis at Ampere-level Current Density

Tensile nanostructured hierarchically porous non-precious transition metal-based electrocatalyst for durable anion exchange membrane-based water electrolysis

Synergistically Coupling P-doped Mo2C@N, P Dual-coped Carbon-nanoribbons as an Efficient Electrocatalyst for Hydrogen Evolution Reaction

One‐Step Fabrication of Ultralow Pt Loading High Efficiency Proton Exchange Membrane for Water Electrolysis by Conventional E‐Beam Metal Deposition

Porous Plate-like MoP Assembly as an Efficient pH-Universal Hydrogen Evolution Electrocatalyst

Enhancing Proton Exchange Membrane Water Electrolysis with a Checkered Carbon Matrix Containing Ir‐Ru Nanoparticles

Nitrogen-Doped Porous Carbon Nanosheets Strongly Coupled with Mo2C Nanoparticles for Efficient Electrocatalytic Hydrogen Evolution

Accelerated Discovery of Multi-Metallic Nanostructured Catalysts for Anion Exchange Membrane Water Electrolyzers: Oxygen Evolution Reaction

Carbonized-nitridated Mo 2 N-MoC heterostructures towards universal-medium hydrogen evolution reaction

Carbon core-shell Pt nanoparticles embedded porphyrin Co-MOF derived N-doped porous carbon for the alkaline AEM water electrolyzer application.

Surface engineering-modulated porous N-doped rod-like molybdenum phosphide catalysts: towards high activity and stability for hydrogen evolution reaction over a wide pH range

Allotrope-dependent activity-stability relationships of molybdenum sulfide hydrogen evolution electrocatalysts