Abstract:Future actively cooled space-borne observatories for the far-infrared, loosely defined as a 1--10 THz band, can potentially reach a sensitivity limited only by background radiation from the Universe. This will result in an increase in observing speed of many orders of magnitude. A spectroscopic instrument on such an observatory requires large arrays of detectors with a sensitivity expressed as a noise equivalent power NEP = 3 $\times 10^{-20}$ $W\surd{Hz}$. We present the design, fabrication, and characterisation of microwave kinetic inductance detectors (MKIDs) for this frequency range reaching the required sensitivity. The devices are based on thin-film NbTiN resonators which use lens-antenna coupling to a submicron-width aluminium transmission line at the shorted end of the resonator where the radiation is absorbed. We optimised the MKID geometry for a low NEP by using a small aluminium volume of $\approx$ 1$\mu m^3$ and fabricating the aluminium section on a very thin (100 nm) SiN membrane. Both methods of optimisation also reduce the effect of excess noise by increasing the responsivity of the device, which is further increased by reducing the parasitic geometrical inductance of the resonator. We measure the sensitivity of eight MKIDs with respect to the power absorbed in the detector using a thermal calibration source filtered in a narrow band around 1.55 THz. We obtain a NEP$_{exp}(P_{abs})\:=\:3.1\pm0.9\times10^{-20}\:W\surd{Hz}$ at a modulation frequency of 200 Hz averaged over all measured MKIDs. The NEP is limited by quasiparticle trapping. The measured sensitivity is sufficient for spectroscopic observations from future, actively cooled space-based observatories. Moreover, the presented device design and assembly can be adapted for frequencies up to $\approx$ 10 THz and can be readily implemented in kilopixel arrays.

Extending KIDs to the Mid-IR for Future Space and Suborbital Observatories

Development of an ultra-sensitive 210-micron array of KIDs for far-IR astronomy

Parallel Plate Capacitor Aluminum KIDs for Future Far-Infrared Space-Based Observatories

Parallel-Plate Capacitor Titanium Nitride Kinetic Inductance Detectors for Infrared Astronomy

High-Sensitivity Kinetic Inductance Detector Arrays for the PRobe Far-Infrared Mission for Astrophysics

Development of Aluminum LEKIDs for Balloon-Borne Far-IR Spectroscopy

Characterization of a Far-Infrared Kinetic Inductance Detector Prototype for PRIMA

Lens Absorber Coupled MKIDs for Far Infrared Imaging Spectroscopy

Modeling of Cosmic Rays and Near-IR Photons in Aluminum KIDs

Development of Lumped Element Kinetic Inductance Detectors for NIKA

Design of microstrip-line coupled kinetic inductance detectors for near infrared astronomy

Ultra-sensitive Super-THz Microwave Kinetic Inductance Detectors for future space telescopes

KSIM: simulating KIDSpec, a Microwave Kinetic Inductance Detector spectrograph for the optical/NIR

Kinetic Inductance Detectors and readout electronics for the OLIMPO experiment

A multi-chroic kinetic inductance detectors array using hierarchical phased array antenna

Design and performance of the antenna coupled lumped-element kinetic inductance detector

Mid-infrared detector development for the Origins Space Telescope

Microfabrication technology for large LEKID arrays : from NIKA2 to future applications

Development of Lumped Element Kinetic Inductance Detectors for the W-Band