TiO2 nanotubes improve physico-mechanical properties of glass ionomer cement

Kamila Rosamilia Kantovitz,Fernando Pelegrim Fernandes,Isabella Vidal Feitosa,Marcela Oliveira Lazzarini,Giovanna Corrêa Denucci,Orisson Ponce Gomes,Priscila Alves Giovani,Kelly Maria Silva Moreira,Vanessa Gallego Arias Pecorari,Ana Flávia Sanches Borges,Francisco Humberto Nociti Jr,Roberta Tarkany Basting,Paulo Noronha Lisboa-Filho,Regina Maria Puppin-Rontani
DOI: https://doi.org/10.1016/j.dental.2020.01.018
Abstract:Objectives: The aim of this study was to determine the physico-mechanical properties of a high viscosity glass ionomer cement (GIC) reinforced with TiO2 nanotubes (TiO2-nt). Methods: TiO2-nt was incorporated into the GIC powder components (Ketac Molar EasyMix™) in concentrations of 0% (control group), 3%, 5%, 7% by weight. Compressive strength (n = 10/group), three point bending for flexural strength (n = 18/group), microshear bond strength to dentin and failure mode (n = 20/group), and surface roughness and weight loss before and after brushing simulation (30,000 cycles) (n = 8/group) were evaluated. Data were submitted to Shapiro-Wilk, ANOVA, Tukey and Chi-square tests (α ≤ 0.05). Results: Addition of 5% of TiO2-nt into GIC presented the highest values for compressive strength and differed from the control, 3% and 7% groups (p = 0.023). There were no significant differences in flexural strength (p = 0.107) and surface roughness before and after the dental brushing (p = 0.287) among the groups. GIC added with 5% TiO2-nt showed the lowest weight loss values (p = 0.01), whereas the control, 3% or 5% TiO2-nt groups presented similar microshear bond strength values (p ≥ 0.05). The 5% TiO2-nt group featured higher microshear bond strength than the 7% TiO2-nt group (p = 0.034). Cohesive in material was the most representative failure mode for all groups. Significance: The incorporation of TiO2-nt did not affect GIC's adhesiveness to dentin, but improved its compressive strength at 5%. Furthermore, TiO2-nt decreased the percentage of weight loss after GIC's surface wear.
What problem does this paper attempt to address?