Abstract:Bioretention systems have become a leading infiltration-based Low Impact Development (LID) practice to reduce urban stormwater runoff volumes and peak flows. Although these systems have performed well in many site-scale field studies, modeling of bioretention systems has received less attention. Additional studies are needed which calibrate various models to field measurements to investigate and optimize the performance of individual LID practices and effectively scale local interventions to the watershed. DRAINMOD-Urban has been successfully applied to bioretention at the site-scale due to its advanced soil–water accounting using the soil–water characteristic curve and its ability to explicitly model underdrains and internal water storage (IWS) zones. At the same time, the U.S. EPA Stormwater Management Model (SWMM) has become one of the most widely used urban drainage models. The latest version, SWMM5, included dedicated LID modules including a routine for bioretention modeling.In this study, DRAINMOD-Urban and the SWMM LID module were compared through detailed analysis of the internal processes of each model as well as through model calibration and output investigation. The objective was to identify the strengths and weaknesses of each model and compare the performance of both models to a single bioretention cell. Both SWMM and DRAINMOD-Urban were evaluated in calibrated and uncalibrated scenarios since urban drainage models often remain uncalibrated for planning scenario analysis. Following calibration, DRAINMOD-Urban was superior for replicating drainage hydrographs (NSE = 0.60) while SWMM produced better overflow hydrographs (NSE = 0.57). Specifically, SWMM often output a maximum drainage rate that caused rectangular drainage hydrographs, but DRAINMOD-Urban was better able to match the shape of measured drainage hydrographs. While the DRAINMOD-Urban model output was in good agreement with measured drainage and overflow event volumes when calibrated (drainage NSE = 0.83, overflow NSE = 0.57–0.66), SWMM was closer to measured volumes even when uncalibrated (drainage NSE = 0.70–0.93, overflow NSE = 0.59–0.81). This study improved existing knowledge of the SWMM LID module by calibrating to field-collected data from a single bioretention cell for the first time in literature. Furthermore, the results of this study indicate an opportunity for model coupling that could combine the strengths and weaknesses of each model and improve bioretention cell modeling.

Assessment of a green roof practice using the coupled SWMM and HYDRUS models

Urban Pluvial Flood Modeling by Coupling Raster-Based Two-Dimensional Hydrodynamic Model and SWMM

Simulation of green roof runoff under different substrate depths and vegetation covers by coupling a simple conceptual and a physically based hydrological model

Methodology to simulate unsaturated zone hydrology in Storm Water Management Model (SWMM) for green infrastructure design and evaluation

Simulations of low impact development designs using the storm water management model

A HYDRUS-1D Based Evaluation of the Effects of Green Roof Designs on Runoff Control

Toward an operational tool to simulate green roof hydrological impact at the basin scale: a new version of the distributed rainfall-runoff model Multi-Hydro

Coupling of SWMM with 2D Hydrodynamic Model for Simulation of Sponge City Construction Scheme

Calibration and validation of SWMM model in two urban catchments in Athens , Greece

Coupling a Distributed Time Variant Gain Model into a Storm Water Management Model to Simulate Runoffs in a Sponge City

Evaluating the stormwater reduction of a green roof under different rainfall events and antecedent water contents with a modified hydrological model

Assessing the performance of blue-green solutions through a fine-scale water balance model for an urban area

SWMM-Based Assessment of the Improvement of Hydrodynamic Conditions of Urban Water System Connectivity

Introduction of basic principle and application prospect for SWMM

Modeling bioretention hydrology: Quantifying the performance of DRAINMOD-Urban and the SWMM LID module

Storm Water Management Model: Performance Review and Gap Analysis.

Modelling the Combined Effects of Runoff Reduction and Increase in Evapotranspiration for Green Roofs with a Storage Layer

Simulation of Urban Rainstorm Waterlogging and Pipeline Network Drainage Process Based on SWMM

Impact and analysis of urban water system connectivity project on regional water environment based on Storm Water Management Model (SWMM)

Land cover based simulation of urban stormwater runoff and pollutant loading

Assessment of Groundwater Recharge in Agro-Urban Watersheds Using Integrated SWAT-MODFLOW Model