Abstract:Experiments were conducted to study the relationship between the transmission ratio (TR) and normal stress, joint roughness, joint number and frequency of incident waves, respectively, when ultrasonic waves pass across a rock mass with one joint and multiple parallel joints oriented normally. The ultrasonic waves were generated and received by pairs of piezoelectric transducers and recorded by an ultrasonic detector. The specimens were subjected to normal stress by a hydraulic jack and loading frame. The jointed rock mass was produced by superposing rock blocks in the study. Rough joints were produced by grooving notches on the planar joints formed by sawing directly. In the case of multiple parallel joints, the overall thickness of specimens was maintained while the joint number changed. Three pairs of P-wave transducers and one pair of S-wave transducers with different frequencies were, respectively, applied and all transducers emitted signals perpendicular to the joints in the experiment. The results indicate that TR increases with increasing normal stress while the increment rate decreases gradually. This is particularly so when the normal stress is high enough that TR will approximate 1 even if the rock mass has many joints. In addition, the experiments indicate that the higher the wave’s frequency, the lower its TR, and this phenomenon is gradually reduced as the normal stress increases. In response to S-waves, TR increases with increase in joint roughness; however, in response to P-waves, TR decreases gradually with increase in joint roughness. For multiple parallel joints in a fixed thickness rock mass with normally incident P-waves, TR does not always decrease with increase in the number of joints, and there is a threshold joint spacing for a certain incident wave: when the joint spacing is smaller than the threshold value, TR will increase with a decrease in joint spacing. The experimental results support similar conclusions based on analytical results drawn by Cai and Zhao (Int J Rock Mech Min Sci 37(4):661–682, 2000), Zhao et al. (Int J Rock Mech Min Sci 43(5):776–788, 2006b) and Zhu et al. (J Appl Geophys 73:283–288, 2011a).

Drug therapy in resuscitation from electromechanical dissociation

Experimental and Numerical Investigation on Shear Failure Behavior of Rock-like Samples Containing Multiple Non-Persistent Joints

Damage Evolution of Rocks Containing a Set of Cross-Joints Based on Acoustic Emission Characteristics

Experimental and numerical studies on the shear mechanical behavior of rock joints under normal vibration loads

Experimental and theoretical study on the propagation characteristics of stress wave in filled jointed rock mass

Experimental Study on the Free-Face True-Triaxial Rockburst Test Considering the Influence of Joints

Experimental and numerical studies on mechanical behavior of pre-stressed infilled rock joints subjected to horizontal vibration loading

Research on the attenuation characteristics of seismic energy in multicoal seam mining and the warning method of rock burst

Experimental study on the shear and acoustic emission characteristics of jointed rocks

Research on instability characteristics and precursory effect of coal-rock parting-coal structures

Numerical and Field Investigations of Acoustic Emission Laws of Coal Fracture under Hydro-Mechanical Coupling Loading

Experimental study on failure mechanical properties and acoustic emission characteristics of soft rock–coal combination under dynamic disturbance

Experimental Study of Ultrasonic Waves Propagating Through a Rock Mass with a Single Joint and Multiple Parallel Joints

Experimental Study on Mechanical Properties and Acoustic Emission Characteristics of Dry and Water-Saturated Soft Rocks under Different Dynamic Loadings

Study on the Fracture of Hard and Thick Sandstone and the Distribution Characteristics of Microseismic Activity

Scale model test study of influence of joints on blasting vibration attenuation

Dynamic response and rockburst characteristics of underground cavern with unexposed joint

Visualization study on stress evolution and crack propagation of jointed rock mass under blasting load

Failure Characteristics and Scale in a Sandstone Joint Subjected to Direct Shear Testing: Experimental Investigation with Acoustic Emission Monitoring

Physical and numerical investigations of bedding adhesion strength on stratified rock roof fracture with longwall coal mining

Experimental Investigation on Mechanical and Acoustic Emission Characteristics of Gassy Coal under Different Stress Paths