Abstract:To reveal the deformation mechanism during tunneling in deep soft ground, triaxial unloading confining pressure tests and triaxial unloading creep tests were carried out on sandy mudstone specimens to study the dilatancy and fracturing behavior of soft rock. In the triaxial unloading confining pressure tests, the stress path and different unloading rates were considered to reflect the unloading characteristics of the excavation methods. The unloading rate effects and the rock damage evolution law are studied. The following conclusions are obtained from the results. Firstly, when the unloading rate is smooth, the peak strengths and deviatoric stress–strain curves under the unloading condition are close to those under the conventional loading condition. Secondly, the post-peak brittle characteristics are more apparent with the increasing unloading rates. Thirdly, the soft rock undergoes five deformation and failure regimes of elasticity, pre-peak unloading damage–dilatancy, post-peak brittle drop, linear strain softening and residual perfect plasticity under quasi-static smooth unloading of mechanized excavation which is mainly focused on in this study. Fourthly, the damage evolution law at the pre-peak damage–dilatancy stage follows an exponential function. Fifthly, during the post-peak stages, multistage microfractures are initiated, propagated and finally coalesced forming a shear-fragmentation band with a certain thickness, accompanied by significant volumetric dilatancy. In the triaxial unloading creep tests, multistep unloading of the confining pressure was applied, while the axial pressure was kept constant. The results show that when the deviatoric stress is larger and the experienced creep time is longer, the unloading effect and creep characteristics become more apparent accompanied with obvious lateral dilatancy, eventually leading to significant creep–dilatancy. The progressive failure with time is caused by the damage accumulating with time-dependent crack expansion, which can be called as ‘time-dependent damage and fracturing’. The reasons for the above evolution process are presented, then the deformation mechanism of soft rock is revealed. The soft rock deformation mainly consists of two parts. One part is the pre-peak damage–dilatancy and post-peak fracture–bulking produced at the excavation unloading instant. The other part is creep–dilatancy caused by time-dependent damage and fracturing in a period of time after excavation. The above-mentioned results of damage, dilatancy and fractures evolution process are in good agreement with the in situ monitoring results and previous studies about the surrounding rock convergence, fracturing and EDZ (excavation damaged zone) development.

Experimental Study on Mechanical Properties and Acoustic Emission Characteristics of Dry and Water-Saturated Soft Rocks under Different Dynamic Loadings

Experimental study on failure mechanical properties and acoustic emission characteristics of soft rock–coal combination under dynamic disturbance

Mechanical properties and acoustic emission characteristics of soft rock with different water contents under dynamic disturbance

Biaxial Creep Test Study on the Influence of Structural Anisotropy on Rheological Behavior of Hard Rock

Study on Characteristics of Failure and Energy Evolution of Different Moisture-Containing Soft Rocks under Cyclic Disturbance Loading

Study on the failure modes of water-bearing soft rock under different low-frequency disturbance

Analysis of Fracture Modes and Acoustic Emission Characteristics of Low‐Frequency Disturbed Water‐Bearing Soft Rock With Different Cyclic Initial Value

Experimental Study on Failure Mechanism of Soft Rock-Coal Bodies in Abandoned Mines under Cyclic Dynamic Loading

Experimental study on the mechanical characteristics of weakly cemented mudstone under different loading rates

Dynamic Response and Damage Regularity of Sandstone with Different Moisture States under Cyclic Loading

Experimental Study on the Dilatancy and Fracturing Behavior of Soft Rock Under Unloading Conditions

Mechanical behaviour and acoustic emission characteristics of the reinforced soft muddy rock under various moisture content levels

Experimental study on dynamic mechanical properties of multidirectional constrained water-bearing coal samples under dynamic-static coupling loading

Mechanical and Acoustic Emission Characteristics of Coal-like Rock Specimens under Static Direct Shear and Dynamic Normal Load

Experimental Study on Mechanical Behavior, Fracture Characteristics, and Acoustic Emission Damage Characteristics of Sandstone Under Triaxial Multistage Stress Disturbance

Study on Mechanical and Acoustic Emission Characteristics of Backfill–Rock Instability under Different Stress Conditions

Mechanical Behavior and Acoustic Emission Characteristics of Sandstone Under Different Cyclic Loading and Unloading Disturbance Rates

Mining-induced static and dynamic loading rate effect on rock damage and acoustic emission characteristic under uniaxial compression

Experimental and Numerical Study of Water–Rock Coupling Creep under Uniaxial Compression

Fracturing and acoustic emission characteristics of saturated reservoir rocks under constant-amplitude-cyclic loading

Mechanical behaviors and failure characteristics of coal-rock combination under quasi-static and dynamic disturbance loading: a case based on a new equipment