Abstract:Accurate information regarding the weight of vehicle loads plays a significant role in maintaining the structural health of bridges. However, the only method currently available for ascertaining the weight of loads is the bridge weigh-in-motion (BWIM) system, which is not widely used because of the high cost of the large device involved. There is therefore a need to develop an effective, low-cost technology to ascertain vehicle loads in relation to spatiotemporal load distribution on long-span bridges. This paper proposes a non-contact vehicle identification methodology to distinguish a vehicle from its load based on machine vision technology and deep learning algorithms. The vehicle information (i.e., type, weight, position, and motion trajectory, etc.) is conveniently obtained from a roadside monitoring surveillance camera, while the axle-weight distribution interval for nine classified vehicle types is obtained from the statistical information of 8,402 delivery vehicles from which the relationship between a unique vehicle type and the corresponding weight information is established. Meanwhile, a dataset containing 8,624 vehicle images was established for training the deep convolutional neural network (DCNN), where nine rough-grained vehicle classifications were contained in order to enhance the generalizability of the network. Optimization analysis was conducted to improve the network accuracy in vehicle types identification. The position of vehicles can also be effectively detected by a faster region-based convolutional neural network (Faster R-CNN), where the pre-trained DCNN with 98.17% vehicle types classification accuracy is employed as the co-shared network layer to enhance computation efficiency. Utilizing the object detection results from the Faster R-CNN and utilizing a Kalman filter, a vehicle in motion could also be simultaneously real-time tracked by the monitoring video, while a graphical user interface (GUI) incorporated into the video camera enabled automatic identification. A post-processing module has been established based on the proposed method, and a field test was conducted to validate the reliability of the system.

Tire⁻Pavement Contact-Aware Weight Estimation for Multi-Sensor WIM Systems

Fusion of Computer Vision and Piezoelectric Tactility Approach to Measuring Moving Vehicle Loads

Vehicle weigh-in-motion technology

Vehicle Weigh-in-Motion System Based on Soft Capacitive Weighing Sensor

Intelligent Weigh-in-Motion System Using Embedded MEMS Sensors for Pavement Monitoring

A Novel Sensor System for Measuring Wheel Loads of Vehicles on Highways

Non-contact weigh-in-motion approach with an improved multi-region of interest method

Capacitive Flexible Weighing Sensor for WIM System

Design of a Capacitive Flexible Weighing Sensor for Vehicle WIM System

A Capacitive Flexible Weighing Sensor and Weighing Measurement

Weigh-in-Motion System Based on an Improved Kalman and LSTM-Attention Algorithm

Factors affecting the accuracy of a computer vision-based vehicle weight measurement system

Non-contact vehicle weight identification method based on explainable machine learning models and computer vision

Novel Weigh-in-Motion Pavement Sensor Based on Self-Sensing Nanocomposites for Vehicle Load Identification: Development, Performance Testing, and Validation

Rigid pavement strain as means of weighing vehicles

Road Condition Estimation for Automotive Anti-Skid Control System Based on BP Neural Network

Experimental Evaluation of Tire Tread Wear Detection Using Machine Learning in Real-Road Driving Conditions

Vehicle weight identification system for spatiotemporal load distribution on bridges based on non-contact machine vision technology and deep learning algorithms

A New Vehicle Dynamic Weighing Based On Tpms

Experimental Platform Development for the Identification of Moving Loads Under the Laboratory Condition