Electromagnetic Coupling Field Effect on Microstructure and Wear Behavior of Laser-Clad 304 Stainless Steel

Weibo Li,Yong Yang

DOI: https://doi.org/10.1007/s11665-024-10280-5

IF: 2.3

2024-10-22

Journal of Materials Engineering and Performance

Abstract:In this study, using 45 steel as the substrate and 304 stainless steel as the cladding layer material, a combined direct current (DC) electric field and alternating magnetic field-assisted laser cladding technique is proposed. While applying an alternating magnetic field around the substrate to be clad, a DC is directly passed through the substrate to regulate the convection inside the melt pool by the simultaneous action of the DC electric field and alternating magnetic field. The results show that under the conditions of laser power P = 1500 W, scanning speed v = 4 mm/s, and spot diameter D = 4 mm, with the increase of the alternating magnetic field intensity in the coupled field, the height of the cladding layer decreases, the width increases, and its morphology becomes relatively flat. When the alternating magnetic field intensity reaches 60 and 80 mT, the grain structure in the middle of the cladding layer shows obvious refinement. With the increase in DC electric field intensity in the coupled field, there is an observed enhancement in the melt depth of the cladding layer. Upon reaching 6 and 8 A of DC electric field intensity, a slight expansion of the fine-grained region on the cladding layer surface is noted. In addition, under the influence of alternating magnetic field intensity within this coupled field, notable improvements are observed in various aspects of cladding layer performance including a marginal increase in micro-hardness, reduction in friction coefficient, enhanced wear resistance, and emergence of Cu-Ni compounds within phases.

materials science, multidisciplinary