Abstract:The mandate assigned by the European Union to the Community Reference Laboratory for residues at the Istituto Superiore di Sanità covers, among other things, the assessment of trace elements in living animals as well as their products. To better protect the health of the consumer, this task aims in particular at harmonizing the procedures in use at the National Reference Laboratories (NRLs) for residues of the Member States for such determinations as well as at developing new approaches wherever the need arises. In this context an investigation was undertaken to appraise the average levels of a number of key elements in several types of honey with special regard to the influence of the various processing steps. Instrumental methods of election for the analysis of this matrix turned out to be inductively coupled plasma atomic emission spectrometry (ICP-AES) and inductively coupled plasma mass spectrometry (ICP-MS) depending on the actual concentrations of the elements of interest. Dissolution of the samples for suitable presentation to the analytical systems could be easily achieved by gentle heating at ca. 50 degrees C, sonication and addition of high-purity water. The ranges ascertained are as follows (in ng g(-1)): As, <0.50-0.70; Cd, <0.50-0.74; Cr, 1.03-3.93; Cu, 144-216; Fe, 191-651; Mn, 223-580; Ni, 17-49; Pb, 3.20-186; Pt, <0.50; Sn, <4-27; V, 1.22-1.94; and Zn, 565-1144. As a rule, concentrations of elements in honey from different beehives were similar. A few exceptions were noted for As, Cu, Fe, Ni and Zn. On the other hand, although data obtained with different analytical approaches for the same types of honey and beehive were generally in good agreement, yet some inconsistencies occurred, as in the case of Cu in freshly collected, extracted and ripened honey, Ni in extracted honey and Fe in ripened honey. These could not be traced back to specific procedural facts; rather, they should be ascribed to the inherent heterogeneity of the raw material. The experience gained with this exploratory study will be exploited to set up wider surveys and to plan the preparation of a new certified reference material in a matrix of honey to the benefit of NRLs for residues.

Determination of As in honey samples by magnetic ionic liquid-based dispersive liquid-liquid microextraction and electrothermal atomic absorption spectrometry

Magnetic dispersive solid-phase extraction based on a novel adsorbent for the detection of triazole pesticide residues in honey by HPLC-MS/MS

Two-step separation and determination of inorganic As species in water, soil and sediment samples by implementing two ionic liquids in dispersive liquid–liquid microextraction with electrothermal atomic absorption spectrometry detection

Study on the simultaneous determination of some essential and toxic trace elements in honey by multi-element graphite furnace atomic absorption spectrometry

Determination of essential and potentially toxic trace elements in honey by inductively coupled plasma-based techniques

A new synthesis, characterization and application chelating resin for determination of some trace metals in honey samples by FAAS

Ionic liquid-linked dual magnetic microextraction of lead(II) from environmental samples prior to its micro-sampling flame atomic absorption spectrometric determination

Speciation of As(III) and As(V) in Food by Magnetic Dispersive Microsolid Phase Extraction with Dispersive Liquid–Liquid Microextraction with Graphite Furnace Atomic Absorption Spectrometry (GFAAS) Detection

Ionic liquid dispersive liquid–liquid microextraction for pesticide residue analysis in honey

ISFME extraction of As species from some real water samples using an imidazolium-based task-specific ionic liquid (TSIL): Synthesis and characterization

Selective determination of As(III) and total inorganic arsenic in rice sample using in-situ μ-sorbent formation solid phase extraction and FI-HG AAS

Determination of traces of copper and zinc in honeys by the solid phase extraction pre-concentration followed by the flame atomic absorption spectrometry detection

Determination of arsenic species using functionalized ionic liquid by in situ dispersive liquid-liquid microextraction followed by atomic absorption spectrometry

Development of salt-induced homogenous liquid-liquid extraction based on ternary deep eutectic solvent coupled with dispersive liquid-liquid microextraction for the determination of heavy metals in honey

Hydride Generation/Condensation System With an Inductively Coupled Argon Plasma Polychromator for Simultaneous Determination of Arsenic, Antimony, Selenium, Lead, Mercury and Tin in Honey

Online Flow-Batch Dispersive Liquid-Liquid Microextraction System for ET AAS Determination of Molybdenum in Water and Complex Matrices

Development of Multiple Monolithic Fiber Solid-Phase Microextraction and Liquid Chromatography-Tandem Mass Spectrometry Method for the Sensitive Monitoring of Aminoglycosides in Honey and Milk Samples

Determination of Trace Cobalt in Water Samples by Ionic Liquid-Dispersive Liquid–Liquid Microextraction and Graphite Furnace Atomic Absorption Spectrometry

Determination of Arsenic in Honey, Propolis, Pollen, and Honey Bees by Microwave Digestion and Hydride Generation Flame Atomic Absorption

Determination of Ultra-Trace Cobalt in Water Samples Using Dispersive Liquid-Liquid Microextraction Followed by Graphite Furnace Atomic Absorption Spectrometry

Hollow fiber liquid phase microextraction combined with electrothermal atomic absorption spectrometry for the speciation of arsenic (III) and arsenic (V) in fresh waters and human hair extracts