Use of Basolite® F300 metal-organic framework for the dispersive solid-phase extraction of phthalic acid esters from water samples prior to LC-MS determination

Javier González-Sálamo,Miguel Ángel González-Curbelo,Javier Hernández-Borges,Miguel Ángel Rodríguez-Delgado
DOI: https://doi.org/10.1016/j.talanta.2018.11.049
IF: 6.1
2019-04-01
Talanta
Abstract:In the present work, a commercial metal-organic framework (Basolite® F300) has been applied for the first time as dispersive solid-phase extraction (dSPE) sorbent of eight phthalic acid esters (PAEs) (butyl benzyl phthalate, bis-2-n-butoxyethyl phthalate, bis-isopentyl phthalate, bis-n-pentyl phthalate, dicyclohexyl phthalate, di-(2-ethylhexyl) phthalate -DEHP-, di-n-octyl phthalate and diisononyl phthalate) and an adipate (bis (2-ethylhexyl) adipate), which is utilized as a PAE substitutive. Milli-Q, pond, tap and waste water were selected as samples. Dihexyl phthalate-3,4,5,6-d4 was used as procedural internal standard. High-performance liquid chromatography mass spectrometry was used for the determination of the target compounds. Optimum dSPE conditions were the following: 50 mL of the water sample (pH 6.0), 120 mg of sorbent and 15 mL of ACN as elution solvent. For the validation of the method, matrix-matched calibration and trueness of the method were addressed, obtaining determination coefficients (R2) higher than 0.9905 and relative recovery values between 70 and 118 % (RSDs < 20 %). The limits of quantification of the method were in the range 22-69 ng/L. Matrix effects were also studied. Different real samples were analysed, finding DEHP in all of them at the low µg/L level.
What problem does this paper attempt to address?