Abstract:Temperature-programmed reaction spectroscopy (TPRS) and direct, isothermal reaction-rate measurements were employed to investigate the oxidation of CO on Pt(111) covered with high concentrations of atomic oxygen. The TPRS results show that oxygen atoms chemisorbed on Pt(111) at coverages just above 0.25 ML (monolayers) are reactive toward coadsorbed CO, producing CO(2) at about 295 K. The uptake of CO on Pt(111) is found to decrease with increasing oxygen coverage beyond 0.25 ML and becomes immeasurable at a surface temperature of 100 K when Pt(111) is partially covered with Pt oxide domains at oxygen coverages above 1.5 ML. The rate of CO oxidation measured as a function of CO beam exposure to the surface exhibits a nearly linear increase toward a maximum for initial oxygen coverages between 0.25 and 0.50 ML and constant surface temperatures between 300 and 500 K. At a fixed CO incident flux, the time required to reach the maximum reaction rate increases as the initial oxygen coverage is increased to 0.50 ML. A time lag prior to the reaction-rate maximum is also observed when Pt oxide domains are present on the surface, but the reaction rate increases more slowly with CO exposure and much longer time lags are observed, indicating that the oxide phase is less reactive toward CO than are chemisorbed oxygen atoms on Pt(111). On the partially oxidized surface, the CO exposure needed to reach the rate maximum increases significantly with increases in both the initial oxygen coverage and the surface temperature. A kinetic model is developed that reproduces the qualitative dependence of the CO oxidation rate on the atomic oxygen coverage and the surface temperature. The model assumes that CO chemisorption and reaction occur only on regions of the surface covered by chemisorbed oxygen atoms and describes the CO chemisorption probability as a decreasing function of the atomic oxygen coverage in the chemisorbed phase. The model also takes into account the migration of oxygen atoms from oxide domains to domains with chemisorbed oxygen atoms. According to the model, the reaction rate initially increases with the CO exposure because the rate of CO chemisorption is enhanced as the coverage of chemisorbed oxygen atoms decreases during reaction. Longer rate delays are predicted for the partially oxidized surface because oxygen migration from the oxide phase maintains high oxygen coverages in the coexisting chemisorbed oxygen phase that hinder CO chemisorption. It is shown that the time evolution of the CO oxidation rate is determined by the relative rates of CO chemisorption and oxygen migration, R(ad) and R(m), respectively, with an increase in the relative rate of oxygen migration acting to inhibit the reaction. We find that the time lag in the reaction rate increases nearly exponentially with the initial oxygen coverage [O](i) (tot) when [O](i) (tot) exceeds a critical value, which is defined as the coverage above which R(ad)R(m) is less than unity at fixed CO incident flux and surface temperature. These results demonstrate that the kinetics for CO oxidation on oxidized Pt(111) is governed by the sensitivity of CO binding and chemisorption on the atomic oxygen coverage and the distribution of surface oxygen phases.

Crystallization kinetics of thin water films on Pt(111): effects of oxygen and carbon-monoxide adspecies

Thermal effects on electronic properties of CO/Pt(111) in water

Kinetics of CO oxidation on high-concentration phases of atomic oxygen on Pt(111)

Oxygen Vacancy-Induced Novel Low-Temperature Water Splitting Reactions on FeO(111) Monolayer-Thick Film

Kinetics of the CO Oxidation Reaction on Pt(111) Studied by in Situ High-Resolution X-Ray Photoelectron Spectroscopy.

A Novel Study of the Growth and Resistivity of Nanocrystalline Pt Films Obtained from Pt(acac)2 in the Presence of Oxygen or Water Vapor

Water Adsorption on A Co(0001) Surface

Intact water adsorption on Co(0001) at 100 K: transition from ordered bilayer to amorphous ice structures

CO Oxidation at the Perimeters of an FeO/Pt(111) Interface and How Water Promotes the Activity: a First-Principles Study.

Single Crystalline Highly Epitaxial Pt Thin Films On (001) Srtio3

High-Pressure Co Oxidation On Pt(111) Monitored With Infrared-Visible Sum Frequency Generation (Sfg)

Theoretical studies on the adsorption and decomposition of H2O on Pd(111) surface

Ab initio molecular dynamics investigation of the Pt(111)-water interface structure in an alkaline environment with high surface OH-coverages

The Effect of Water on the CO Oxidation on Ag(111) and Au(111) Surfaces: A First-Principle Study

Observation of Water Dissociation on Nanometer-Sized FeO Islands Grown on Pt(1 1 1)

The preparation of and water adsorption on thin films of niobium oxide on Pt(111)

Slab Model Studies of Water Adsorption and Decomposition on Clean and X- (X = C, N and O) Contaminated Pd(111) Surfaces

Water-promoted oxygen isotope exchange on a Pt4+/MgO catalyst

Crystallisation of Ice in Charged Pt Nanochannel

Sfg and Stm Studies of the Pt(111) Crystal Face at Atmospheric Co and Oxygen Pressures: Preparation of Platinum Nanocluster Arrays

Early Stages During the Oxidation of HCOOH on Single-Crystal Pt Electrodes As Characterized by Infrared Spectroscopy