Abstract:Underground coal exploitation often results in land-surface subsidence, the rate of which depends on geological characteristics, the mechanical properties of the rocks, and the applied extraction technology. Since mining-related subsidence is characterized by “fast” displacement and high nonlinearity, monitoring this process by using Interferometric Synthetic Aperture Radar (InSAR) is very challenging. The Small BAseline Subset (SBAS) approach needs to predefine an a priori deformation model to properly estimate an interferometric component related to displacements. As a consequence, there is a lack of distributed scatterers (DS) when the selected a priori deformation model deviates from the real deformation. The conventional differential SAR interferometry (DInSAR) approach does not have this limitation, since it does not need any deformation model. However, the accuracy of this technique is limited by factors related to spatial and temporal decorrelation, signal delays due to the atmospheric artifacts, and orbital or topographic errors. Therefore, this study presents the integration of DInSAR and SBAS techniques in order to leverage the advantages and overcome the disadvantages of both methods and to retrieve the complete deformation pattern over the investigated study area. The obtained results were evaluated internally and externally with leveling data. Results indicated that the Kriging-based integration method of DInSAR and SBAS can be effectively applied to monitor mining-related subsidence. The root-mean-square Error (RMSE) between modeled and measured deformation by InSAR was found to be 11 and 13 mm for vertical and horizontal displacements, respectively. Moreover, DInSAR technique as a cost-effective and complementary method to conventional geodetic techniques can be applied for effective monitoring fast mining subsidence. The minimum and maximum RMSE between DInSAR displacement and specific leveling profiles were found to be 0.9 and 3.2 cm, respectively. Since the SBAS processing failed in subsidence estimation in the area of maximum deformation rate, the deformation estimates outside the maximum rate could only be compared. In these areas, the good agreement between SBAS and DInSAR indicates that the SBAS technique could be reliable for monitoring the residual subsidence that surrounds the subsidence trough. Using the proposed approach, we detected subsidence of up to −1 m and planar displacements (east–west) of up to 0.24 m.

Principles of ground deformation monitoring at open pit mine with use of GPS technology: KWB "Adamów" in Turek case study"

Validation of the accuracy of geodetic automated measurement system based on GNSS platform for continuous monitoring of surface movements in post-mining areas

Modern Solution for Fast and Accurate Inventorization of Open-Pit Mines by the Active Remote Sensing Technique—Case Study of Mikoszów Granite Mine (Lower Silesia, SW Poland)

Investigation of Stability of Precise Geodetic Instruments Used in Deformation Monitoring

Integration of DInSAR and SBAS Techniques to Determine Mining-Related Deformations Using Sentinel-1 Data: The Case Study of Rydułtowy Mine in Poland

Accuracy Tests and Precision Assessment of Localizing Underground Utilities Using GPR Detection

Monitoring active open-pit mine stability in the Rhenish coalfields of Germany using a coherence-based SBAS method

Application of Combined Geophysical Methods for the Examination of a Water Dam Subsoil

The Geodetic Monitoring of the Engineering Structure – A Practical Solution of the Problem in 3D Space

Rectifying Discrepancies Between GB-SAR Images and Terrain Model Caused by Measurement Deviations in Open-Pit Mines

Terrestrial laser scanning in the construction of a numerical model geometry related to underground post-mining facility

Study on the Positioning Accuracy of the GNSS/INS System Supported by the RTK Receiver for Railway Measurements

Monitoring Strategy of Geological Hazards Using Integrated Three-dimensional InSAR and GNSS Technologies with Case Study

Study on subsidence monitoring technology using terrestrial 3D laser scanning without a target in a mining area: an example of Wangjiata coal mine, China

Comparison of the monitoring of surface deformations in open-pit mines with Sentinel-1A and TerraSAR-X satellite radar data

Monitoring system for the construction of buildings in the area of mining exploitation impact

Crustal deformation from GNSS measurement and earthquake mechanism along Pieniny Klippen Belt, Southern Poland

Multi-GNSS high-rate RTK, PPP and novel direct phase observation processing method: application to precise dynamic displacement detection

Research on Monitoring and Forecasting Ground Deformation at Mining Area

Ground Surface Subsidence Monitoring Using Sentinel-1 in the "Kostolac" Open Pit Coal Mine

Multi-sensor and multi-temporal approach in monitoring of deformation zone with permanent monitoring solution and management of environmental changes: A case study of Solotvyno salt mine, Ukraine