Abstract:Because the transportation mode of straddle monorail is that the vehicle runs in the state of hugging the track, its track beam is usually a narrow-high cross section. In order to study the static and dynamic characteristics and variation law of prefabricated steel-concrete composite beam of straddle monorail with "cluster-distributed studs" (CDS), a full bridge test model with a scale ratio of 1 : 3 was made. Relevant theoretical analysis, numerical simulation, and model test were carried out, and the data of structural frequency and damping, load-deflection curve, and section height-strain curve were obtained. The results show the following: (1) the equivalent vertical bending stiffness of the composite track beam of straddle monorail is nonlinear. The greater the load, the faster the stiffness decrease, and the greater the difference with the theory of composite beam with "uniformly distributed studs" (UDS). (2) At the same section, the deformation of steel beam and concrete slab is not coordinated along the height direction. The strain value of concrete slab is significantly larger than that of the upper edge of steel beam, so it is difficult to apply the plane-section assumption. (3) Compared with all the measured results of the track beam test, the results of the detailed shell-solid FEM model based on the load-slip curve obtained by push-out test are close to them, and the maximum error is 11.4% difference in stress. (4) Compared with the results obtained by the theoretical formula of the UDS, the results obtained by the theoretical formulas of the CDS based on a "correction coefficient of vertical bending stiffness" proposed in this paper show less deviation comparing to the measured results of the track beam test and are more resilient. When the correction coefficient is 0.9, the maximum error is 23.8% difference in stress. In the design of this kind of structure, the proposed formula can be used for early scheme comparison and later size optimization. Compared with the detailed shell-solid FEM model, the proposed formula significantly reduces the design workload.

Mechanical Property Analyses of Two Types of Steel–Concrete Composite Track Beams

Experimental Studies on Shear Strength of Steel–Concrete Composite Beams

Mechanical Behavior of Box Girder Bridge with Partial Corrugated Steel Webs

RESEARCH ON FLEXURAL PERFORMANCE OF DOUBLE-STEEL REINFORCED CONCRETE BEAM

Experimental studies of the bearing capability of a type of steel-concrete composite slab

PLASTIC ANALYSIS OF SHEAR BEHAVIOR OF COMPOSITE STEEL-CONCRETE BEAMS

Static and Dynamic Characteristics of Steel-Concrete Composite Track Beam of Straddle Monorail with Cluster-Distributed Studs

Mechanical Behavior of Steel–HFRC Composite Girders

Shear Mechanical Property of Composite Box Girder with Corrugated Steel Webs

Experimental Investigation of a Slip in High-Performance Steel-Concrete Small Box Girder with Different Combinations of Group Studs

A New Type of Steel–concrete Composite Channel Girder and Its Preliminary Experimental Study

Investigation of the shear resistances of steel-concrete-steel composite structures with bidirectional webs

Study on Mechanical Properties of Multi-Cavity Steel-Concrete Composite Beam

Analyses of Steel-Concrete Composite Transfer Beams in Flexure

Temperature Effect of Composite Girders with Corrugated Steel Webs Considering Local Longitudinal Stiffness of Webs

Static Characteristics of Improved Composite Box Girder with Corrugated Steel Webs

Analysis of Shear Lag Effect of Steel-Concrete Composite Box Girders with Straight Steel Webs

Experimental study on flexural behavior of steel-laminated concrete (NC and UHPC) composite beams with corrugated steel webs

Preliminary study of channel steel-concrete composite beam and application

Beam-Truss Model of Steel-Concrete Composite Box-Girder Bridges

Research on Static Load Capacity for Curved Steel-Concrete Composite Girder Bridge